Operation; Maintenance And Storage - Beurer MP 50 Instrucciones Para El Uso

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 23
Note
• Batteries do not have their full load capacity from the beginning. In order to achieve
the full load capacity of the batteries, they should be fully charged, completely
discharged and then fully charged once more prior to initial operation of the device.
This recharge/discharge cycle should be repeated as often as possible to extend
the service life of the batteries.
• The callus remover can be used on dry or wet skin. Removal of calluses is more
effective on dry skin.
• When used on dry skin, the skin must be completely dry and free from grease.
• Do not use any cream before removing calluses.
• Do not remove too much of a callus as it may otherwise grow back again more
strongly.

5. Operation

• Press the on/off switch to switch on the device.
• If you press the on/off switch again, the speed setting increases. The LED light ensures
optimal lighting conditions so that you can see and remove calluses better.
• Move the device slowly and evenly over the callus. Make sure you hold the device
vertically at a 90° angle to the callus. To achieve optimum results, it may help to move the
device over the callus in different directions.
Changing the attachment:
• To change an attachment, press the unlock button and take the attachment off the
device. You can remove the fixing cap from the callus attachment by pressing the
attachment hooks outwards.
• If you wish to remove highly callused areas, use the coarse callus attachment.
• If you wish to remove slightly callused areas or to smooth your skin, use the fine callus
attachment.
• Place the protective cap for skin cells on the selected callus attachment to safely collect
skin cells.

6. Maintenance and storage

WARNING
• Unplug the device each time before cleaning.
• Clean the device using only the methods specified. Under no circumstances may
liquid enter the device or the accessory.
• Clean the callus attachment with the cleaning brush. We recommend that you
moisten this beforehand with alcohol to guarantee a hygienic clean.
Brush the attachments out from behind while you turn the roller by hand.
• Make sure that the relevant callus attachment is completely dry before you put it
back on the device.
• Do not use the device again until it is completely dry.
• Do not clean the device in the dishwasher.
• Do not use any abrasive cleaning products or hard brushes.
14
Tabla de contenido
loading

Tabla de contenido