Storage - Oreck dutchTech DTX 1400A Guia Del Usuario

R Motor F
eplacing
R E
eplacing xhaust
ADVANCED HEPA FILTER INSTALLATION:
E N G
ilter
Unplug unit from wall
outlet. Remove the dustbag
and carrier to access the
motor filter grill.
Using the tab located at
top of filter grill, lift filter
grill out of unit.
Remove filter from grill and
replace with new filter.
Change the motor filter
every fifth dustbag
replacement.
F
ilter
Unplug unit from wall
outlet. Remove exhaust grill
from back of unit by
pressing down and pulling
out on the tab located at
the top of the grill.
Discard used exhaust filter.
Place new filter in grill. Set
grill tabs in slots. Press top
of grill to snap closed. The
exhaust filter should be
changed with every fifth
dustbag replacement.
Note: Exhaust filter not
needed if Advanced Hepa
Filter is used.
Remove exhaust grill. Install
Advanced Hepa Filter by
aligning tabs in slots and
pressing top to snap closed.
L I S H
S
8
After filter has snapped into
place, push filter upwards.
Note: Replace Hepa Filter
once a year or every fifth
dust bag replacement.
torage
Turn unit off and unplug
cord from outlet. Rewind
cord by pressing cord
rewind pedal. Do not allow
plug to whip when
rewinding.
When storing DTX 1400A,
stand vacuum cleaner on
end. Insert telescopic wand
clip into slot located on
base of vacuum.
The power nozzle
assembly connected or
disconnected will stand in
an upright position.