TO ASSEMBLE TELESCOPIC WAND WITH STANDARD
NOZZLE OR ACCESSORIES.
E
N
DTX 1400B G
etting
Insert power handle into
telescopic wand until
button locks.
To unlock the wand, step
on the release button
located on the power
nozzle. Gently lean wand
back for vacuum use.
Extend telescopic wand by
holding telecscopic length
adjustment and pulling
power handle.
Connect the hose by firmly
inserting end of hose into
canister intake opening
until it clicks.
To disconnect hose, turn
hose lock on canister
intake to unlock hose and
remove.
Insert power handle into
larger end of telescopic
wand (while holding down
button lock, firmly push
power handle into wand
until seated).
G
L
I
S
H
R
eady for
O
perating
Polarized Plug Notice
This product is equipped with a polarized alternating
current line plug (a plug having one blade wider than the
other). This plug will fit into the power outlet only one way.
This is a safety feature. If you are unable to insert the plug
fully into the outlet, try reversing the plug. If the plug
should still fail to fit, contact an electrician to replace the
obsolete outlet. Do not defeat the purpose of the polarized
plug. Note: Hose must be connected for unit to operate.
( ll )
6
U
se
Insert small end of
telescopic wand into either
standard nozzle or
accessory tools.
I
nstructions
Pull plug from unit and
insert into wall outlet.
Press the On/Off pedal
located at the rear of the
canister to turn on.
Turn handle switch to ( l )
position for unit only or ( ll )
position for unit and power
nozzle. The On/Off pedal
on canister must be On for
the handle switch to
( l )
operate.