tau BIUNO Manual De Instrucciones página 18

> ENGLISH
STANDARD MANUAL OPERATION
If the door has to be operated manually due to a power cut or
malfunction of the automated system, use the release device as
follows:
1. pull the handle down to unlock the motor;
2. stop the handle in the "unlocked" position (Fig. 2);
3. manually move the leaf of the hinged door.
RESTORING NORMAL OPERATION
To prevent an involuntary pulse from activating the door during the
manoeuvre, cut power to the system before relocking the operator.
1. Return the handle in the working position (Fig. 1).
DESCRIPTION
The BIUNO automation has been designed for
release system makes it possible to manually move the leaf in the event of a malfunction or of a power failure.
Even if your automated system satisfies regulatory safety standards, this does not eliminate "residue risks", that is, the possibility of
dangerous situations being generated, usually due to irresponsible and/or incorrect use. For this reason we would like to give you some
suggestions on how to avoid these risks:
- Before using the system for the first time: ask your fitter to explain how residue risks can arise and read the instructions and warnings
in the user handbook that your fitter will have given you. Keep this manual for future use and, if you should ever sell your automated
system, hand it over to the new owner.
- Your automated system carries out your commands to the letter: irresponsible and/or incorrect use may cause it to become
dangerous. Do not use the system if people, animals and/or objects enter its operating area.
- IT IS NOT A TOY! Make sure children do not play near the system and keep the remote control device out of their reach.
- Faults: If you notice any abnormal behaviour, disconnect the system from the power supply immediately and perform the manual release
operation (see figure). Do not attempt to repair the door but call in your fitter: the system will operate manually as it did before installation.
- Maintenance: to ensure long life and totally safe operation, the system required routine maintenance, just like any other piece of
machinery. Establish maintenance times together with your fitter. Tau recommends a frequency of 6 months for normal domestic
installations but this may vary depending on the intensity of use (always every 3000 work cycles).
N.B.: All controls, maintenance work and/or repairs may only be carried out by qualified personnel.
- Do not modify the plant or the relative programming and adjustment parameters: your fitter will see to that.
N.B. Final testing, routine maintenance and any repairs must be documented by the fitter (in the relative spaces) and such
documents kept by the owner of the system (IF THE DOCUMENTS ARE NOT PRODUCED, THE WARRANTY WILL EXPIRE).
- Disposal: At the end of system life, make sure that it is demolished by qualified personnel and that the materials are recycled or
disposed of according to local regulations.
The manual manoeuvre must ONLY be done with the door stopped and AFTER disconnecting power from the electrical control unit.
N.B.: if your remote control unit (if supplied) starts working badly after a time, or does not work at all, the batteries may be flat (they can last
from several months to 2/3 years depending on what type is used). This can be seen from the fact that the transmission confirmation LED
gets dimmer or only turns on for brief moments. Before contacting your fitter, try exchanging the battery with one from a good transmitter: if
this is the reason for the fault, simply replace the battery with another one of the same type.
If you wish to add a new automated system to your house, contact your fitter and we at Tau to have the advice of a specialist, the most
developed products on the market, best operation and maximum automation compatibility.
Thank you for reading these suggestions and we trust you are fully satisfied with your new system: please contact your fitter for any further
requirements.
1
to move articulated doors in industrial environment.
18
2
A simple and effective type of cord