Fuel Characteristics; Pellet Storage; Handling And Transportation - Palazzetti Ecofire TWIGGY Manual De Instalación Y Mantenimiento

3

FUEL CHARACTERISTICS

3.1 Fuel characteristics
The pellets (Fig. 2) are a compound consisting of
various types of wood pressed with mechanical
procedures in compliance with the environmen-
tal protection regulations, and the only fuel
required for this type of appliance.
The efficiency and thermal potential of the appli-
ance may vary according to the type and quality
of the pellets used.
We recommend the use of class A1 pellets (ISO
17225-2 standard, ENplus A1, DIN Plus or NC
444 category "High Performance NF Pellets
Biofuel Quality").
The appliance is equipped with a pellet container
tank of the capacity indicated in the character-
istic data table in the attached Product Booklet.
The loading compartment is positioned at the
top, it must always be open for loading of the pel-
lets and must remain closed while the appliance
is operating.
It is prohibited to use the appliance as
an incinerator to burn rubbish.

3.2 Pellet storage

Pellets must be kept in a dry place, not
too cold and the bags must be kept
sealed.
It is advisable to keep a number of bags of pellets
in the room where the appliance is being used or
in an adjacent room provided it is at the correct
temperature and humidity and at a safe distance
(at least one meter) away from heat sources.
004771070 - 17/11/2020
ITALIANO ENGLISH
Fig. 2
DEUTSCH
Wet and/or cold pellets (5 °C) reduce the thermal
potential of the fuel resulting in the need for more
cleaning maintenance of the brazier (unburned
material) and of the firebox.
Pay particular attention to the stor-
age and handling of pellet bags. Their
crushing and the formation of sawdust
must be avoided.
If sawdust is placed in the appliance tank it could
cause the pellet loading system to block.
The use of poor quality pellets can compromise
the normal functioning of the appliance and lead
to losing the guarantee.
4 HANDLING AND
TRANSPORTATION
The appliance is delivered complete with all the
parts required.
Pay attention to the tendency for the appliance
to become unbalanced.
The centre of gravity of the appliance is carried
towards the front.
Bear in mind the above also when moving the
appliance on the transport stand. It is advisable
to unpack the appliance only when it has arrived
at the installation site.
Proceed to move and unpack the ap-
pliance with suitable means.
Make sure that children do not play with the pack-
aging components (e.g. films and polystyrene):
Danger of suffocation!
During moving, lifting, and unpacking of the
appliance the following is absolutely necessary:
• always keep it in an upright position;
• never tip it over into a horizontal position;
• never tilt it on the front to avoid breaking the
glass of the firebox door.
FRANÇAIS ESPAÑOL
41