Tabla de contenido
Idiomas disponibles
Idiomas disponibles
6.3 Circulation of ducted air
The stove is designed for ductable rear hot air
connection.
In order to connect the stove to the ducted heat-
ing system, it is necessary to remove the rear cap
(A) and fit the 80 mm diameter pipe (B) supplied
(Fig. 22).
B
Connect an 80 mm diameter tube on one side
to the inlet and to the air distribution nozzle
on the other. Fasten with a hose clamp with
a diameter of 80 mm (Fig. 23).
50
A
Fig. 22
Fig. 23
When the stove is used to heat 2 or more adjacent
rooms, it is essential to encourage recirculation
of the ambient air to uniform the temperature in
the various rooms.
Do not use PVC pipes for ducting
Remove the grille fixing screw to allow the lower
grille to slide in its guides (Fig. 24).
The hot air normally comes out through the
upper grille, so in order to channel the air through
the rear tube it is necessary to close the upper air
passage slots.
Then use the Allen wrench supplied and insert
it into the appropriate slot in the upper grille.
Acting on it, it will be possible to vary the flow of
hot air (Fig. 25).
Fig. 24
Fig. 25
004771070 - 17/11/2020
Capítulos
Tabla de contenido
