Trouble Shooting; Warning, Maintenance And Warranty - SEA USER 2-24V DG Manual Del Usuario

Sistemi Elettronici
di Apertura Porte e Cancelli
International registered trademark n. 804888
Advises
Make sure all Safety LED are turned ON
All not-used N.C. contacts must have jumpers
Problem Found
Motor doesn't respond to any
START impulse
Gate doesn't move while the
motor is running
Gate doesn't reach the complete
Open / Closed position
The gate opens but doesn't
close
The gate doesn't close
automatically
MAINTENANCE
Considering the number of working cycles and the kind of gate, if the gate has changed the clutches and doesn't work it's necessary to
periodically proceed, with the learning times reprogramming on the electronic control unit.
Periodically clean the optical systems of the photocells.
REPLACEMENTS
Any request for spare parts must be sent to:
SEA S.p.A. - Zona Ind.le, 64020 S.ATTO - Teramo - Italia
SAFETY AND ENVIRONMENTAL COMPATIBILITY
Disposal of the packaging materials of products and/or circuits should take place in an approved disposal facility.
REGULAR PRODUCT DISPOSAL (electric and electronic waste)
(It's applicable in EU countries and in those ones provided with a differential waste collection)
The brand that you find on the product or on documentation signals that the product must not be disposed off together with other domestic
waste at the end of life cycle. In order to avoid any possible environmental or health damage caused by irregular waste disposal, we
recommand to separate this product from other forms of waste and to recycle it in a responsible way in order to provide the sustainable re-use of
material resources. Domestic users are invited to contact the retailer where the product has been purchased or the local office in charge of all
the information related to differential watse collection and recycling of this kind of product.
STORING
T
min
- 20°C
Materials handling must be made with appropriate vehicles..
WARRANTY LIMITS
For the guarantee see the sales conditions on the official SEA price list.
SEA reserves the right to make any required modification or change to the products and/or to this manual without any advanced notice
obligation.
42
67410756
®

TROUBLE SHOOTING

Possibile Cause
a.) Jumper missing on one of the N.C. Contacts
b.) Burnt fuse
a.) The motor is in the released position
b.) There is an obstacle
a.) Wrong setting of the limit switches
b.) Error on programming
c.) Gate is stopped by an obstacle
d.) The fitting geometry is inadequate
e.) Torque or speed too low
a.) The photocell contacts are not closed
b.) Ammeter alarm
a.) Pause time set to high
b.) Control unit in semi-autom. logic
Page for both installer and user
WAREHOUSING TEMPERATURES
T
Max
+ 65°C
English
Dampness
min
5% Not condensing
REV 04 - 03/2013
USER 2 - 24V DG
Solutions
a.) Check the connections or the jumpers on the
connections of the safety edge, of the stop and
of the photocell
b.) Replace the burned fuse on the control unit
led 1 turned on.
a.) Re-lock the motor
b.) Remove obstacle
a.) Set limit switches
b.) Repeat programming
c.) Remove obstacle
d.) Check fitting geometry following the operator
installation manual
e .) Increase torque parameter
a.) Check the jumbers or the signals on the flashing
lamp or on the dispaly
b.) Check if the ammeter alarm has intervened and
eventually increase the torque parameter.
a.) Adjust pause time
b.) Adjust the automatic or security logic
Dampness
90% Not condensing
Max