Menu
Submenu 1
setup
main menu
4
alarm
1
The "Measurement" submenu only appears, if it is enabled in the "Setup" menu.
2
The "Water flow meter" submenu only appears, if a "Water flow meter" is enabled in the "Setup" menu.
3
Depending on the type of water flow meter enabled.
4
The alarm settings only appear if "Measurement" is enabled in the setup menu.
5
Depending on the setting in the "Setup" menu.
Operator menus (part 2)
Menu
Submenu 1
chlorine dioxide
6
calibration
pH
ORP
7
manual operation
controller ClO2
6
Press the [Cal] button to access the calibration menu.
7
Press the [Man] button for manual operation.
Operators can view the current input value of the water flow
meter as well as the impulses/second, or the value in mA and the
calculation in percent, see section
water flow
meter.
The value is also displayed, if the defined input values are
exceeded or not reached (a water flow meter malfunction is
visible here).
Submenu 2
Submenu 3
Deutsch
language
English
(all listed)
date
time
date/time
daylight.sav.t.
change
code function
delete
display
contrast
alarm off
alarm value ClO2
alarm on
off
dos. time monit.
on
Submenu 2
CAL meas. value
CAL result
CAL cycle
CAL meas. value
CAL result
CAL cycle
CAL meas. value
CAL result
CAL cycle
on/off
9.8.3 Current input value for
Submenu 4
Begin, end, time shift
(± x hours), off
alarm value 1: 0.15 mg/l
alarm value 2: 0.70 mg/l
hysteresis: 0.01
alarm delay: 0 sec.
max. dosing time
Submenu 3
Submenu 4
slope: µA, mg/l
on/off
GRUNDFOS,
DIN/NIST, others
slope µA, mg/l
asym. mV
on/off
asym. mV
on/off
Submenu 5
upward violation or
downward viol.
upward violation or
downward viol.
Submenu 5
19