Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Total Restaurant Supply - https://totalsupply1.com - Toll Free 1-800-944-9304 - Local 507-288-9454
ELECTRICAL CONNECTION
Referring to the wiring diagram in the "Electrical Connections" section of this manual, connect the heater wire leads
as shown. If short lengths of the lead wires were left as indicators, connect the replacement heater leads to those
points of connection and discard the short indicator lengths.
NOTE: If one of the heater leads connects to another wire through a wire connector, obtain a properly sized, twist-
on wire connector for this purpose.
Replace the pilot light and switch in the switch box and attach the switch cover to complete the job. Energize the
walk-in cooler to resume operation.
PANEL CLEANING ANd MAINTENANCE RECOMMENdATIONS
During the course of uncrating, handling and installation, the panel surfaces of your walk-in cooler or freezer may
have become stained or dirty. Cleaning all metal type surfaces, door trim and gaskets can be performed with a
mild detergent and hot water. It is important that you remove all excess soap and dry the surfaces
thoroughly. Never, under any circumstances, use an abrasive or alkaline solution.
Occasionally it may become necessary to clean the interior surface for sanitary purposes. A mild solution of baking
soda and warm water will tend to impart a clean, sweet smell to the interior should odors occur from spillage or
container breakage. Never leave standing water inside the walk-in cooler or freezer.
37
2940 Hwy 14 W, Rochester, MN 55901
W
-i
m
alk
n
ainTenance
© 2014 Nor-Lake, Inc 10/14 Rev. G 132617
Tabla de contenido
