Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Total Restaurant Supply - https://totalsupply1.com - Toll Free 1-800-944-9304 - Local 507-288-9454
W
-i
i
alk
n
nsTallaTion
EXISTING WALL
HIGHEST POINT
(EXAMPLE ONLY)
2'' MINIMUM
After the first screed section is positioned, it must be LEVELED PERFECTLY not only over its length
but, across its width, as well. To achieve this, shimming material will probably be required. Vinyl floor
tile is ideally suited for this purpose.
IMPORTANT! EVERY SECTION OF SCREED MUST BE SUPPORTED AT LEAST EVERY
acceptable.
12'' BY EITHER THE BUILDING FLOOR OR BY SHIMMING (Figure 3).
Assuming that the first screed section has been perfectly leveled, refer to the screed diagram and select an
adjoining screed section and level it perfectly in both directions, shimming wherever necessary. Continue
leveling the remainder of the screed sections until the entire assembly is in position. Check the assembly
to make sure that the outer edges are located exactly on the drawn outline on the building floor.
12
- s
s
iTe
elecTion
2940 Hwy 14 W, Rochester, MN 55901
EXISTING WALL
2'' MINIMUM
EXACT DIMENSIONS
OF SCREED ASSEMBLY
(REFER TO SCREED
DIAGRAM)
Figure 2
LEVEL THOSE SHOULDERS IN BOTH DIRECTIONS
However, other materials that are resistant to rotting or compression are
, B
P
ase
Note: All
sealers lettered
alike are
interchangeable.
LEVEL
SHIMMING MATERIAL
Figure 3
RePaRaTion
8'-1 1/2''
OVERALL SCREED WIDTH THAT
CONTACTS THE FLOOR IS 5 1/2''
5 1/2''
Sealers may also be
numbered by part
number
(Screed Diagram)
HIGHEST POINT
(EXAMPLE ONLY)
39 1/2''
Note: Corners are shipped in two pieces.
Installer to silicone together during the installation
© 2014 Nor-Lake, Inc 10/14 Rev. G 132617
Tabla de contenido
