Electrical Connections; The First Wash Cycle; Technical Data - Hotpoint Ariston WDD 9640 Manual Del Usuario

Connecting the drain hose
!
We advise against the use of hose extensions; if it is
absolutely necessary, the extension must have the same
diameter as the original hose and must not exceed 150 cm
in length.

Electrical connections

Before plugging the appliance into the electricity socket,
make sure that:
• the socket is earthed and complies with all applicable
laws;
• the socket is able to withstand the maximum power load
of the appliance as indicated on the Technical Data Plate
fixed on the machine;
• the power supply voltage falls within the values indicated
on the Technical Data Plate fixed on the machine;
• the socket is compatible with the plug of the washer-dr-
yer. If this is not the case, replace the socket or the plug.
!
The washer-dryer must not be installed outdoors, even
in covered areas. It is extremely dangerous to leave the
appliance exposed to rain, storms and other weather
conditions.
!
When the washer-dryer has been installed, the electricity
socket must be within easy reach.
Connect the drain hose,
without bending it, to a drai-
nage duct or a wall drain
located at a height between
65 and 100 cm from the
floor;
alternatively, rest it on
the side of a washbasin
or bathtub, fastening the
duct supplied to the tap
(see figure). The free end
of the hose should not be
underwater.
!
Do not use extension cords or multiple sockets.
!
The cable should not be bent or compressed.
!
The power supply cable must only be replaced by autho-
rised technicians.
Warning! The company shall not be held responsible in the
event that these regulations are not respected.

The first wash cycle

Once the appliance has been installed, and before you use
it for the first time, run a wash cycle with detergent and no
laundry, using the cycle "Auto Clean"

Technical data

Model WDD 9640
width 59.5 cm
Dimensions height 85 cm
depth 60,5 cm
from 1 to 9 kg for the wash programme
Capacity
from 1 to 6 kg for the drying programme
Electrical
please refer to the technical data plate fixed
to the machine
connections
maximum pressure 1 MPa (10 bar)
Water connections minimum pressure 0.05 MPa (0.5 bar)
drum capacity 62 litres
Spin speed up to 1400 rotations per minute
Wash: programme
Energy rated
(2 press of the button)
nd
Drying: the smaller load must be dried by
programmes
selecting the "EXTRA" dryness level. The
according to
load must consist of 3 sheets, 2 pillowcases
regulation
and 1 hand towel;
EN 50229
the remainder of the load must be dried by
selecting the "EXTRA" dryness level.
This appliance conforms to the following EC
Directives:
- 2004/108/EC (Electromagnetic Compatibility)
- 2006/95/EC (Low Voltage)
- 2002/96/EC
GB
; temperature 60°C
; using a load of 9 kg.
3