Wolf ICBDF304 Guia De Instalacion página 7

INSTALLATION
Anti-Tip Bracket
ANTI-TIP BOLT ADJUSTMENT
Once the bracket is secure, adjust the anti-tip bolt so the
top of the washer is 22 mm maximum from the floor. Slide
the range into the opening and verify the anti-tip bolt is
engaged. Refer to the illustrations below.
ANTI-TIP
ANTI-TIP
BOLT
22 mm
MAX
ENGAGED
Anti-tip bolt adjustment. Anti-tip bolt engaged.
Sub-Zero, Sub-Zero & Design, Sub-Zero & Snowflake Design, Dual Refrigeration, The Living Kitchen, Great American Kitchens The Fine Art of Kitchen Design, Wolf, Wolf & Design, Wolf Gourmet, W & Design, red colored knobs, Cove, and Cove & Design, are registered trademarks and service marks of Sub-Zero Group, Inc. and its subsidiaries.
All other trademarks are property of their respective owners in the United States and other countries.
Electrical Connection
Open the terminal box to expose the screws with corre-
sponding numbers. Run the cord through the strain relief
hole and into the terminal box. Two concentric knockouts
are provided to allow for permanent or cordset wiring of the
unit.
SINGLE PHASE INSTALL (LINE, NEUTRAL, GROUND)
Loosen the 1, 5, and ground screws. Attach the Neutral wire
to the number 5 position. Line should be attached to the 1
position and attach the ground to the corresponding ground
screw.
DEVICE
Single phase wiring diagram.
3PHASE INSTALL (L1, L2, L3, NEUTRAL, GROUND)
Loosen the 1, 2, 3 and remove the copper bars. Loosen 5
and ground screws. Attach L1 to position 1. L2 to position
2. L3 to position 3. Neutral wire to position 5 and attach the
ground to the corresponding ground screw.
WARNING
Copper bars must be removed from positions 1, 2, and
3 when connecting to 3phase power.
3phase wiring diagram.
Gas Supply Connection
All connections to the gas piping must be wrench-tightened.
Do not overtighten or allow pipes to turn when tightening.
If a flexible metal connector is being used, verify it is not
kinked, then attach the gas supply line to the regulator on
the range. Open the valve and check for leaks by placing a
liquid detergent solution onto all gas connections. Bubbles
around connections indicate a gas leak. If a leak appears,
close the shut-off valve and adjust connections.
TROUBLESHOOTING
Troubleshooting
IMPORTANT NOTE: If the range does not operate properly,
follow these troubleshooting steps:
• Verify electrical power is supplied to the range.
• Verify the gas supply shut-off valve is in the open
position.
• If the range does not operate properly, contact Wolf
factory certified service. Do not attempt to repair the
range. Wolf is not responsible for service required to
correct a faulty installation.
wolfappliance.com | 7