Reset To Default Settings; Perform A Ventilation Test; Change Display Language; Change Date And Time - Ingeteam INGECON SUN 40TL U M480 Manual De Instalacion Y Uso

Ingeteam
N/S Inverter serial number.
FW APP Firmware application
FW BOOT Firmware start-up.
FW LCD APP Firmware application of the display.
FW LCD BOOT Firmware start-up of the display.

10.20. Reset to default settings

If you want to delete all configurations made and accumulated values, thus returning the unit to the default
settings, you need to perform a reset.
To perform a factory reset access Main menu > Advanced settings > Factory reset. Press

10.21. Perform a ventilation test

Occasionally you need to test the proper performance of the unit´s fans. These units have the option of performing
a ventilation test.
To perform the ventilation test access Main menu > Settings > Ventilation Test. Press
unit´s fans start to turn. Wait until the display shows that the test has finished. If one or several of the fans do not
turn, a ventilation fault is displayed. If all ventilators turn, the test's result is positive.
The ventilation test only checks the turning of the fans. A positive ventilation test alone does
not indicate that the system's ventilation status is correct. To assure proper performance of the
ventilation system, also check that there are no elements obstructing air passage and that the fans
are properly installed.

10.22. Change display language

To change display language, access the Main menu > Settings > Language.

10.23. Change date and time

To change the inverter´s date and time access Main menu > Settings > Date and time.

10.24. Perform a partial delete of accumulated data

These inverters have total and partial meters for energy produced, connected time to grid and number of
connections to grid made. This data may be viewed in Main menu > Monitoring.
If you wish to delete the partial meters, access Main menu > Settings > Partial delete.

10.25. Block inverter screen

If you want to block the keypad/screen together to avoid undesired changes access Main menu > Advanced settings
> Block display and enable the block. To unblock it, press it in this order and long-press for three seconds
. Re-access Main menu > Advanced settings > Block display and disable block.
Pressing you access the configured country / regulations information.
46
1/11/2016 1/11/2016 10:17 AM 10:17 AM
to start the reset.
to start the test. The
ABO2012IQM01_ - Installation and Operation Manual
Display control