Tripp-Lite SRCOOL2KWM Manual Del Propietário página 9

Operation
Warning: Install the unit according to the instructions in the "Installation" section before attempting to operate it.
Power
Turn the unit on or off by pressing the "POWER" button.
The unit has a 3.5-minute compressor delay in order to prevent potential circuit overloads at
start up.
Automatic Restart Feature
The unit will turn on and resume operation automatically when power is restored after a power
outage. The unit will use the same settings that it used immediately before the power outage
occurred.
Note: If the power outage is brief, the unit will run the fan alone for 3.5-minutes before resuming normal
operation. The delay allows the compressor to depressurize so the unit will function properly when it enters
Cool mode.
Cool Mode
Pressing the "FUNCTION" button cycles between Cool mode and Dehumidify mode. The
"COOLING" LED remains illuminated when Cool mode is active.
Press the TEMP+ and TEMP- buttons to set the temperature in Cool mode. The selected
temperature is shown on the numeric display. Once set, the desired temperature will blink five
times, after which the display will show the current room temperature.
Press the "FAN SPEED" button to cycle between high, medium and low fan speeds. An LED
illuminates to indicate the selected fan speed. When speed is set on AUTO, the unit will
automatically select a fan speed based on the set and ambient temperatures. If ambient
temperature is lower than the set temperature, the fan will run and the "COOLING" LED will
blink to indicate that the compressor is off. When cooling resumes, the "COOLING" LED will
remain illuminated.
Dehumidify Mode
Pressing the "FUNCTION" button cycles between Cool mode and Dehumidify mode.
The "DEHUMIDIFY" LED illuminates when Dehumidify mode is active. In Dehumidify mode, the
fan runs at a fixed speed and temperature controls are disabled. For optimal performance in
Dehumidify mode, close windows and doors, remove the drain plug and route user-supplied
drain line to external drainage.
Timer
The "TIMER" button allows you to schedule the unit to turn on or off automatically.
Timer On
(Note: The unit must be off to activate the Timer On function. Confirm that mode, temperature
and fan speed settings are correct before activating the Timer On function.)
Activate the timer by pressing the "TIMER" button. Pressing or holding down the "TIMER"
button allows you to set the "delayed on" time. The number of hours is shown on the numeric
display. The number will flash on the screen five times, then display the time remaining before
the unit will power on.
Timer Off
(Note: The unit must be on to activate the Timer Off function.)
Activate the timer by pressing the "TIMER" button. Pressing or holding down the "TIMER"
button allows you to set the "delayed off" time. The number of hours is shown on the
numeric display. The number will flash on the screen five times before returning to the current
temperature.
Quiet Control Mode
The unit includes a Quiet Control Mode which regulates the cooling via the microprocessor to
achieve quieter operation levels when noise is an issue.
To activate Quiet Control Mode, first set the desired temperature. After the display LED stops
flashing, press the "QUIET" button. The Quiet LED will turn on. The set temperature will
automatically increase by 2° F / 1° C per hour for the next two consecutive hours for a total
gain of +4° F / +2° C after two hours, keeping the setting temperature constant from that
point on.
9