Assembly And Preparation - Evolution EVOMAG 28 Instrucciones Originales

FIG. 1
EVOMAG75 shown above.
Others machine are very similar.
FIG. 2
EVOMAG75 shown above.
Others machine are very similar.
FIG. 3
EVOMAG75 shown above.
Others machine are very similar.

ASSEMBLY AND PREPARATION

WARNING: These machines must not be connected to a
power source until all assembly and preparation has been
completed and a safety check carried out.
Note: All these machines share many similar features and
operating systems. Read these instructions carefully. Where
there are specific requirements for a particular machine these
will be acknowledged in the text.
accessories are present and correct.
WARNING: Enlist competent help when lifting this machine.
ensuring that they are fully screwed home. (Fig. 1)
supplied fixing screws. (Fig. 2)
using the screw(s) provided.
connector' which is screwed into the coolant inlet port. (Fig. 3)
Note:
push the plastic collar towards the brass body and withdraw
the delivery tube.
Note: For some operations it may be convenient to remove the
coolant tank and delivery tube and use an alternative method
of coolant application.
GEAR SELECTION
EVOMAG75
GEAR No Load
RPM
1
200/120
2
260/150
3 390/230
4
490/290
20
www.evolutionpowertools.com
CUTTERS TAPS
2-3/8" - 3" 9/16" - 15/16"
(60mm - 75mm) (15mm - 24mm)
1-3/4" - 2-3/8" 9/16"
(45mm - 60mm)
(15mm or less)
1-3/8" - 1-3/4"
(35mm - 45mm)
1-3/8"
(35mm or less)
N/A
N/A