Setting Up; Coolant/Lubricant Delivery - Evolution EVOMAG 28 Instrucciones Originales

SETTING UP

Note: These machines should only be used
for hole boring/drilling whilst attached to the
work-piece by the electromagnetic base.
EVOMAG75 can also be used for tapping holes
if it is fitted with a suitable clutched chuck (not
supplied). Follow the instructions supplied
by the chuck manufacturer when conducting
tapping operations.
WARNING: Ensure that any operator has
read and understood this manual. Attention
should be drawn particularly to the section on
intended and prohibited uses of this machine
contained within this manual.
WARNING: These machines are intended
for use in any position, but only if the
electromagnet is in full working order and has
sufficient hold on the work-piece.
exercised if the machine is to be used on a
vertical surface or in an inverted position.
attached to the work-piece and preferably pass
through the carrying handle of the machine.
both the machine and to the work-piece in
such a way as to ensure that the machine
cannot become completely detached from
the work-piece in the event of magnet
deactivation.
as an alternative to the magnet for clamping
purposes.
person responsible for workplace safety
(Safety Officer) before cutting operations are
commenced.
www.evolutionpowertools.com

COOLANT/LUBRICANT DELIVERY

Note: It is recommended that high quality
water soluble oil is used as other coolants/
lubricants may have a high viscosity and not
flow easily to the cutter.
lubricant liquid.
position.
and free from any rust, coatings or other
contamination.
energise the electromagnet by operating the
red rocker switch.
the work-piece.
will prevent a vacuum being created in the tank
as fluid is delivered to the cutter.
delivery process.
piece until the cutter teeth are just about to
touch the work-piece, and the pilot pin has
been pushed up into the cutter.
fluid is flowing freely onto the work-piece.
required.
Note: In some circumstances and when the
machine is orientated in some ways, liquid
coolant delivery may not be possible. If this is
to the cavity of the cutter and directly to the
work-piece before cutting operations begin.
during the cutting process.
WARNING:
the cutter are completely stationary.
24