Evolution EVOMAG 28 Instrucciones Originales página 21

www.evolutionpowertools.com
operations.
as general guidance only, and reference should be made to any
information supplied by the cutter manufacturer.
WARNING: Never attempt to change gear whilst the machines
the arbor must be completely stationary.
EVOMAG75
Note: It is recommended that the speed required is set before
the machine is connected to the power supply.
The EVOMAG75 has a four (4) speed gearbox. The set speed is
determined by the position of the two (2) sliding gear selection
buttons. (Fig. 4)
the machine. (Fig. 5)
required position.
relative position of the two (2) selector buttons for all the speeds
available.
Note: To aid gear selection and to ensure that the gears mesh
correctly, it may be helpful to turn the machine's arbor whilst
sliding the selector buttons.
ROTATIONAL DIRECTION
EVOMAG75
This machine is equipped with a 3 position switch (Fig. 6)
which allows the operator to select the rotational direction of
down is reverse.
WARNING: Be aware that if the motor is switched on with
arbor will begin to rotate.
FIG. 4
FIG. 5
FIG. 6
21
NO LOAD R.P.M
FULL LOAD R.P.M
200
120
260
150
390
230
490
290
EN
ES
FR