Assembly And Preparation - Evolution EVOMAG42 Instrucciones Originales

www.evolutionpowertools.com

ASSEMBLY AND PREPARATION

Fig. 1
Fig. 2
Fig. 3a
Fig. 3
WARNING: Mag Drills must not be connected to a power
source until all assembly and preparation has been
completed and a safety check carried out. Evolution Mag
Drills should only to be used on non-coated Mild Steel which
is free from paint or loose rust etc.
Remove the machine from the case and check that all accessories
are present and correct.
WARNING: All Magnetic Drilling machines are heavy. Enlist
competent help when lifting these machines.
• Place the machine onto a clean, sturdy work surface.
• Attach the three handles into the spindle hub ensuring that they
are fully seated. (Fig. 1)
• Attach the Safety Guard and secure in place using the supplied
fixing screws. (Fig. 2)
• Attach the coolant/lubrication bottle to its service position. Use
the tapped hole located at the top left of the machines casing
and the Ø6 screw (provided). (Fig. 3)
• Insert the 'free' end of the supply tube into the 'quick connector'.
Note: To release the delivery tube from the quick connector
(Abb.3a) push the collar towards the brass union and withdraw
the delivery tube.
Note: For some operations it may be convenient to remove the
coolant/lubricant bottle and supply tube and use alternative
methods of coolant or lubricant application.
TESTING - All Evolution Magnetic Drilling Machines
WARNING: All Evolution Magnetic Drilling machines have Class
1 insulation and must be earthed. Any power socket that this
machine is connected to must be grounded to earth. Ensure
that both operating switches are in the 'OFF' position before
connecting the power cord to the socket.
WARNING: The power cord assembly is a custom terminated one.
Replacement should only be carried out by a qualified technician.
Use only replacement parts recommended by Evolution Power
Tools.
WARNING: Do not perform any testing with a cutter or drill
installed in the machine.
• Place the machine onto a piece of clean 10 mm thick mild steel
plate that is larger than the magnetic base of the machine.
• Connect the plug into a mains supply outlet and switch on the
socket (UK only).
• Operate the rocker switch on the machines switch panel to
energise the magnet. (Fig. 4)
13
EN