Safety Advice - Evolution EVOMAG 28 Instrucciones Originales

www.evolutionpowertools.com
mains power supply cannot be interrupted or
compromised accidentally.
power socket, as any variation in voltage
caused by the connected appliances could
result in the electromagnet deactivating
generator set, ensure that the generator set
is reliable and well maintained, and that the
fuel tank contains sufficient fuel to allow
completion of the task.
strongly recommended.
TRANSPORTING AND HANDLING.
Magnetic Drills are heavy machines, and care must
be taken when handling or transporting them.
When transporting or moving a Magnetic
Drill, always use the carrying handle or other
carrying aids provided.
drilling head is in its lowest position and
locked in place.
cutter installed.
coolant system has been drained of coolant
fluid.
in a vehicle, ensure that it is laid on its side
and secured to prevent movement. Ideally
transport it inside its blow moulded case (if
provided).
cord and plug dragging along the ground
(severe trip hazard). Secure the cord on the
machine before transporting.
using the mains cord.

Safety Advice

Carrying a Magnetic Drilling System
Although compact, Magnetic Drilling
Systems are heavy. To reduce the risk of back
injury, enlist competent help whenever you
have to carry or lift a Magnetic Drill.
lifting. Bend your knees so that you can lift
with your legs not your back. Use the lifting/
carrying handle(s).
cord. Serious damage will be caused to the cord
connections and insulation. This could result
in electric shock, fire or serious mechanical
malfunction if the machine is used again.
lowest position to guard against unexpected
movement.
ancillary screws for tightness before moving
or carrying the machine.
PRE USE CHECKS
Before every use cycle check:
The mains plug for any damage. If damage is
evident the plug must be replaced.
damage. If any damage is evident the machine
must not be used until the damage has been
repaired by a qualified technician using genuine
replacement parts where necessary.
machine must not be used without a serviceable
safety guard fitted.
the feed spindle boss.
serviceable with no damaged links or connectors
(safety chain) or damaged webbing or buckle
(safety strap). If damage is found replace the safety
chain or strap.
and operates smoothly and without any
binding or excessive sideways movement. The
cutting head should not fall freely under its
own weight.
Note: Detailed instructions on how to
check and adjust the dovetail slides of these
machines are given in the Maintenance section
of this Instruction Manual.
13
EN
ES
FR