Tools Required; Measurement And Marking - Petsafe Staywell 900 Serie Manual De Instalación

Before installing your cat flap
please read the following step-by-
step instructions carefully.

Tools required

• Masking or
Painter's Tape
• Level
• Pencil
• Ruler
• Jig or Keyhole Saw
• Drill
• 5 mm ( 3 / ") Drill Bit
16
• 13 mm (½") Drill Bit
• Phillips Screwdriver
• Tape Measure
• Sand Paper
• Safety Equipment

Measurement and marking

Measure the belly height of your cat. This is usually 100 mm to 150 mm (Fig. 1).
Mark this measurement on the outside of your door and draw a straight
horizontal line 169 mm (Fig. 2).
Usually this line will be the bottom of the hole you cut in your door
– the frame of the cat flap will be slightly lower. With Magnetic Cat
Flaps it is important that the cat is able to approach the cat flap without
obstacle. There should be a level area in front of the cat flap outside
which is sufficient for the cat to stand with all four paws on the
same level.
4
FIG.1
Cutting a hole for your cat flap
a) In Wood
The cat flap requires a square cut-out of 169 mm x 169 mm (Fig. 3).
FIG.3
Not to scale - for best results you should refer
to the enclosed cutting template.
www.petsafe.net
FIG.2
(x)
(x)
Wooden doors
169 mm
169 mm