Replacing The Lamp; Troubleshooting - Zanussi ZOB10401WK Manual De Instrucciones

7. First lift carefully and then remove the glass
panel.
8. Clean the glass panel with water and soap. Dry
the glass panel carefully.
When the cleaning is completed, install the glass
panel and the oven door. Do the above steps in the
opposite sequence.
The screen-printing zone must face the inner side
of the door. Make sure that after the installation the
surface of the glass panel frame on the screen-
printing zones is not rough when you touch it.
Make sure that you install the internal glass panel in
the seats correctly.

TROUBLESHOOTING

WARNING! Refer to Safety chapters.
WHAT TO DO IF...
Problem
You cannot activate or operate
the oven.
The oven does not heat up.
2
1
Possible cause
The oven is not connected to
an electrical supply or it is con-
nected incorrectly.
The oven is deactivated.

REPLACING THE LAMP

Put a cloth on the bottom of the interior of the
appliance. It prevents damage to the lamp glass
cover and the cavity.
WARNING! Danger of electrocution!
Disconnect the fuse before you
replace the lamp.
The lamp and the lamp glass cover
can be hot.
1. Deactivate the appliance.
2. Remove the fuses from the fuse box or
deactivate the circuit breaker.
The back lamp
1. Turn the lamp glass cover counterclockwise to
remove it.
2. Clean the glass cover.
3. Replace the lamp with a suitable 300 °C heat-
resistant lamp.
4. Install the glass cover.
Check if the oven is correctly
connected to the electrical
supply (refer to the connection
diagram if available).
Activate the oven.
Remedy
15