Cleaning And Maintenance - cecotec BAMBA PRECISIONCARE PROCLIPPER TITANIUM Manual De Instrucciones

• The bottom and top blade should be positioned parallel to each
other.
4. The ��� t ooth of the top blade (from the left) must cover the ���
tooth of the bottom blade.
5. The top-right tooth of the top blade must touch the top-right
large tooth of the bottom blade.
6. Tighten both screws.
How to adjust the cutting length
1. Blade lever:
The cutting length can be adjusted through the blade lever during
operation or before the appliance is switched on.
Lift the lever for shorter haircuts, or push it down for longer-length
haircuts.
2. Clip-on guide comb:
Depending on the type of haircut, the clipper can be operated with or
without the comb attachment.
Place the attachment comb onto the cutting edge of the cutting set and
press it down onto the cutting set until it clicks into position.

5. CLEANING AND MAINTENANCE

• Turn off and disconnect the device from the mains supply before
cleaning, assembling or disassembling any of its parts.
• Do not use compressed air, abrasive scouring pads, powders or
cleaners to clean the product.
• Do not immerse the appliance's body in water or any other liquid,
or place it under running water.
• Clean the clipper and the attachments after each use.
• When any of the parts of the device are washed, dry them
thoroughly before storing or using them again.
• Do not wrap the cord around the device to store it.
EN
45