Tabla de contenido
Idiomas disponibles
Idiomas disponibles
•
Only use extension cables that are suitable for
the power rating of the machine with a minimum
thickness of 1.5 mm
. If you use a extension
2
cable reel, always fully unroll the cable.
Technical data
Charger
Input of charger
Output of charger
Rechargeable battery
Battery charging time
No-load speed
Weight
Noise and vibration
Sound pressure (Lpa)
Acoustic power (Lwa)
Uncertainty (K)
Vibration
Uncertainty (K)
Vibration level
The vibration emission level stated in this instruction
manual has been measured in accordance with
a standardised test given in EN 60745; it may be
used to compare one tool with another and as a
preliminary assessment of exposure to vibration
when using the tool for the applications mentioned
-
using the tool for different applications, or with
different or poorly maintainted accessories,
may significantly increase the exposure level
-
the times when the tool is switched off or when
it is running but not actually doing the job, may
significantly reduce the exposure level
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work
patterns
DESCRIPTION (FIG. A)
Your multitool has been designed for light sanding,
sawing and scraping applications.
1. On/off switch
2. Speed adjustment wheel
3. Mounting point for accessories
4. Grip
ASSEMBLY
Before assembly, always switch off the
machine
CDA1095
100-240V~ 50/60Hz 15W
13,5V d.c. 400mA
12 V Li-ion 1.5 Ah
3-5 hours
5,000 - 18,000 min
-1
0.7 kg
94 dB(A)
105 dB(A)
3 dB(A)
11.240 m/s
2
1.5 m/s
2
The battery must be charged before firstuse.
Removing the battery from the machine
•
Push the battery unlock buttons and pull the
battery out of the machine
Inserting the battery into the machine
Ensure that the exterior of the battery is clean and
dry before connecting to the charger or machine.
•
Insert the battery (2) into the base of the
machine
•
Push the battery further forward until it clicks
into place.
Charging the battery (with the charger)
•
Plug the charger plug into an electrical outlet
and wait for a while. The LED indicator will
lighten up and show the charging status.
LED
Charger status
Red
Battery charging in progress
Green
Battery charging finished, battery fully charged
•
Fully charging the 1.5Ah battery may take up
to 240 minutes.
•
After the battery is fully charged remove the
charger plug from the outlet and remove the
battery from the charger.
When the machine is not being used
over a longer period of time it is best to
store
Mounting and removing the sanding pad and
the sanding paper (fig. B)
The sanding pad and the sanding paper must be
used for sanding applications.
Mounting
•
Place the machine on a table with the mounting
point (3) facing upwards.
•
Loosen the Allen screw (7) using the Allen key
(5).
•
Mount the sanding pad (9) to the mounting point
(3).
•
Tighten the Allen screw (7) using the Allen key
(5).
•
Mount sanding paper (10) with the required
grain size onto the sanding pad (9). Make sure
that the perforation in the sanding paper (10)
corresponds with the perforation on the sanding
pad (9).
-
Use coarse sanding paper (grain 50) for
sanding rough, uneven surfaces.
EN
5
Tabla de contenido
