Dimensions - Parker Pneudri Midi Plus DME012 Guia Del Usuario

Minimum Operating Pressure
Maximum Operating Pressure DME012 - DME030
Maximum Operating Pressure DME040 - DME080
Minimum Operating Temperature
Maximum Inlet Air Temperature
Maximum Ambient Air Temperature
Standard Electrical Supply
Optional Electrical Supply
Nominal Dewpoint
Optional Dewpoint
Nominal ISO 8573.1 : 2001 Classification
Optional ISO 8573.1 : 2001 Classification
Standard Thread Connections
Optional Thread Connections
Approvals
OH0373.9C (DME012 - DME030)
CRN
OH0372.9C (DME040 - DME080)
CSA
Before continuing with the installation and commissioning of this equipment:
Ensure that it is correctly sized for the inlet pressure, taking into consideration the pressure drop caused by the valves, pipes and filters within
the system. Allowance should be made for purge air loss. The dryer should be typically sized at 1 bar (14 psi/0.1MPa) below nominal
compressor output pressure.
The purge air flow is factory set for 6 bar g (87 psi g) minimum system pressure. Should the minimum supply pressure be lower than this figure
the purge air flow must be reset in order to maintain the specified dewpoint. Please contact your local domnick hunter office for assistance.
Ensure that it is correctly sized for inlet temperature to meet the dewpoint specified.
-40°C (-40°F) or -70°C (-100°F).
Ensure that the electrical supply voltage and frequency meet the requirements detailed within this specification and on the equipment rating
plate.

2.1.1 Dimensions

Refer to diagram A1 in Annex A for dimensions and weights
Note: Weights include filters but are not shown in the diagram.
Noise Level
173682 (LR56310
230 V 1ph 50 Hz
110 V 1ph 60 Hz
4
EN
4 bar g
58 psi g
16 bar g
232 psi g
13 bar g
190 psi g
o
5
C
o
41 F
o
50 C
o
122 F
o
55 C
o
131 F
<75 dB(A)
o
-40 C
o
-40 F
o
-70 C
o
-100 F
Class 2 Water
Class 1 Water
BSPP
NPT
Description