Typical Jet Pump Installation - Utilitech LPT14 Manual De Instrucciones

 LQ %2,/(5
DRAIN
)LJXUH  6WHS 

TYPICAL JET PUMP INSTALLATION

STEP 1
7KUHDG  LQ ;  LQ QLSSOH LQWR SUHVVXUH WDQN 7KUHDG
tank cross into nipple so that the two 1/4 in. holes in
tank cross face upward. Thread street tee into front
of tank cross. Thread pressure relief valve into top
of street tee and thread 3/4 in. boiler drain into front
of street tee.
TANK CROSS
 LQ %2,/(5 '5$,1
)LJXUH  6WHS 
67(3 
Thread 1 in. male PVC adapter into the inlet side
of tank cross.
1 in. MALE PVC
ADAPTER
)LJXUH  6WHS 
PRESSURE
RELIEF VALVE
 LQ 35(6685(
RELIEF VALVE
The complete installation should look like the drawing
shown below. See Figure 4.
SUBMERSIBLE PUMP WITH VERTICAL TANK
STEP 3
7KUHDG RQH HQG RI  LQ ;  LQ EUDVV QLSSOH LQWR
bottom of pressure switch. Thread other end into left
1/4 in. hole of tank cross. Thread pressure gauge into
right 1/4 in. hole of tank cross. Cut and cement as many
sections and couplings of PVC pipe needed to connect
the 1 in. male PVC adapter to pump discharge.
 LQ ;  LQ
NIPPLE
Figure 7: Step 3
The complete installation should look like the drawing
shown below. See Figure 8.
TO
SYSTEM
PRESSURE
RELIEF VALVE/
BOILER DRAIN/
STREET TEE
BASE MOUNTED JET PUMP WITH VERTICAL TANK
7
)LJXUH 
PRESSURE
SWITCH
PRESSURE
GUAGE
VALVE
 LQ 3/8*
PRESSURE
GAUGE
OPTIONAL
GATE VALVE
TO
WELL
MALE PVC
ADAPTER
PRESSURE
SWITCH
Figure 8