Draining For Servicing Or For Winter; Diaphragm Tank Installation; General Materials; Typical Submersible Pump Installation - Utilitech LPT14 Manual De Instrucciones

DRAINING FOR SERVICING OR FOR WINTER

The system should be drained before it is disconnected for servicing, or if it is inoperative for an extended
SHULRG RI WLPH RU LI LW LV LQ GDQJHU RI IUHH]LQJ 7R 'UDLQ
‡ )ROORZ WKH LQVWUXFWLRQV LQ \RXU SXPS LQVWDOODWLRQ PDQXDO WR GUDLQ WKH SXPS
‡ 2SHQ WDQN GUDLQ FRFN WR GUDLQ WDQN
‡ 'UDLQ DOO SLSLQJ WR D SRLQW  IHHW EHORZ JURXQG OHYHO

DIAPHRAGM TANK INSTALLATION

Diaphragm tanks are recommended for clear water applications. Vertical tanks are the most commonly
XVHG WDQNV +RZHYHU KRUL]RQWDO WDQNV DQG LQOLQH WDQNV PD\ EH XVHG ZKHUH VSDFH LV PRUH FULWLFDO 6HH
Tank Specifications for tank capacity.

General Materials

‡ 2QH FDQ 39& FHPHQW UHDG LQVWUXFWLRQV FDUHIXOO\ ‡ 2QH FDQ WKUHDG FRPSRXQG UHDG LQVWUXFWLRQV FDUHIXOO\
‡ 2QH  LQ JDWH YDOYH ‡ 2QH  LQ UHOLHI YDOYH ‡ (QRXJK ULJLG  LQ 39& SLSH DQG FRXSOLQJV WR UHDFK IURP
SXPS WR SUHVVXUH WDQN WR VHUYLFH OLQH ‡ 2QH PDOH  LQ 39& DGDSWHU ‡ 2QH  LQ ;  LQ WDQN FURVV RU
  LQ ;  LQ GHSHQGLQJ RQ DFFHSWDQFH ILWWLQJ VHH &KDUW  ‡ 7ZR  LQ SOXJV ‡ 2QH  LQ ERLOHU
GUDLQ ‡ 2QH  LQ VWUHHW WHH
REMINDER: All joints and connections must be airtight. A single pin-hole leak will prevent the proper operation of
the system. Use thread compound on all threaded connections unless specified otherwise.

TYPICAL SUBMERSIBLE PUMP INSTALLATION

STEP 1
Complete pump assembly and electrical connections
as specified in pump installation manual. Place tank
in desired location and level it.
67(3 
Thread tank tee into pressure tank so that the two
3/8 in. holes in the tee face upward. Thread street
tee into front of tank tee. See Figure 1.
TANK TEE
STREET TEE
)LJXUH  6WHS 
3/8 in. PLUGS
STEP 3
Thread 3/4 in. male PVC adapter into the inlet side
of tank tee. See Figure 2.
 LQ 0$/(
PVC ADAPTER
)LJXUH  6WHS 
67(3 
Thread pressure relief valve into top of street
tee. Thread the 1/2 in. boiler drain into front of
street tee. Cut and cement as many sections and
couplings of PVC pipe needed to connect 3/4 in. male
PVC adapter to pump discharge. See Figure 3.
6