Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Before returning the Gage for service...
1. Install new or newly recharged batteries in the proper alignment as
shown within battery compartment
2. Clean the measurement opening using the cleaning card (pg. 5)
3. Perform a Hard Reset (pg. 9)
4. Verify accuracy (pg. 6)
5. If issue is not resolved, Update (pg. 13) your PosiTector gage body and
re-attempt measurements.
IMPORTANT:
If you must return the Gage for service, please fill out and include the
Service Form located at www.defelsko.com/support with the Gage. Be
sure to also include the probe, your company name, company contact,
telephone number and fax number or email address.
Limited Warranty, Sole Remedy
DeFelsko's sole warranty, remedy, and liability are the express
limited warranty, remedy, and limited liability that are set forth on
its website: www.defelsko.com/terms
This manual is copyrighted with all rights reserved and may not be reproduced or transmitted, in whole or
part, by any means, without written permission from DeFelsko Corporation.
DeFelsko and PosiTector are trademarks of DeFelsko Corporation registered in the U.S. and in other countries.
Other brand or product names are trademarks or registered trademarks of their respective holders.
Every effort has been made to ensure that the information in this manual is accurate. DeFelsko is not
responsible for printing or clerical errors.
Returning for Service
and Limited Liability
www.defelsko.com
© 2017 DeFelsko Corporation USA
All Rights Reserved
14
Tabla de contenido
