Electrical Connection - ELICA EVV636SS Guía De Instalación, Uso Y Mantenimiento

Connect Vent System
1 Install transition on top of hood (if removed for shipping)
with 4 - 4 x 8 mm sheet metal screws.
A. Vent transition
B. 4 x 8 mm screws
For vented installations only:
1 Fit vent system over the exhaust outlet.
2
Measure from the bottom of the air deflector to the
bottom of the hood outlet. Cut the ductwork at the
measured dimension.
Roof outlet
Wall
outlet
3 Seal connection with clamps.
4 Check that back draft dampers work properly.

Electrical Connection

I WARNING
ELECTRICAL SHOCK HAZARD.
I WARNING
DISCONNECT POWER BEFORE SERVICING.
REPLACE ALL PARTS AND PANELS BEFORE OPERATING.
FAILURE TO DO SO CAN RESULT IN DEATH OR
ELECTRICAL SHOCK.
8
A
B
Dimension
to measure
1 Disconnect power.
2 Remove terminal box cover.
3
Remove the knockout in the terminal box cover and install
a UL listed or CSA approved
B
C
B.
C. Junction box cover screws
4 Run home power supply cable through strain relief, into
terminal box.
D
A. Home power supply cable
B. UL listed or CSA approved
strain relief
C. Black wires
5 Use UL listed wire connectors and connect black wires
(B) together.
6 Use UL listed wire connectors and connect white wires (A)
together.
I WARNING
ELECTRICAL SHOCK HAZARD.
I WARNING
ELECTRICALLY GROUND BLOWER.
CONNECT GROUND WIRE TO GREEN AND YELLOW
GROUND WIRE IN TERMINAL BOX. FAILURE TO DO SO
CAN RESULT IN DEATH OR ELECTRICAL SHOCK.
7 Connect green (or bare) ground wire from home power
supply to yellow-green ground wire (D) in terminal box
using UL listed wire connectors.
8
Tighten strain relief screw.
9
Install terminal box cover.
10 Check that all light bulbs are secure in their sockets.
11 Reconnect power.
⁄ " strain relief.
1
2
A
A. Knockout
Junction box cover
B
A
E
F
C
D. UL listed wire connectors
E. White wires
F. Green (or bare) and
yellow-green ground wires