Tabla de contenido
Idiomas disponibles
Idiomas disponibles
External extraction system:
Fit dust extraction nozzle (see chapter on
Accessories). Connect a suitable extraction device.
Use a suction hose with a 35 mm connector
diameter. See Accessories section.
7. Cleaning, Maintenance
Empty dust collection box (4).
- Open cleaning flap (5).
- Empty dust collection box (4).
- Remove fluted filter (6) and knock off dust stuck to
filter or remove with brush.
- When inserting, ensure that the fluted filter (6) is
inserted in the lateral guides.
Clean the machine regularly. This includes
vacuum cleaning the ventilation louvres on the
motor.
Replacing a worn support plate (2)
- Remove fixing screws (on lower side of support
plate).
- Remove support plate.
- For replacement support plates, refer to the
Accessories chapter.
- Mount support plate.
- Refit fixing screws (on lower side of support plate)
and tighten.
Replacing support plate brake / braking ring
If the idling speed of the support plate increases in
the course of time, the braking ring is worn and must
be replaced in a service workshop for Metabo
power tools.
Note: If abrasive material (e.g. gypsum, etc.) is
being sanded, the braking ring inevitably wears
faster.
8. Tips and Tricks
Do not press the device too firmly against the
surface being sanded. This does not improve, but
rather impairs, the sanding performance.
To optimise the extraction performance, empty the
dust collection box (4) in good time and clean the
fluted filter (6).
Use a suitable sanding disc to achieve the best
possible work results:
Removal of old paint layers = P 40
Pre-sanding of wood = P 60, P 80
Finishing of wood = P 100, P 120
Sanding of veneers, sealing primer, filler,
paint = P 180, P 240
9. Accessories
Use only genuine Metabo accessories.
If you need any accessories, check with your
dealer.
For dealers to select the correct accessory, they
need to know the exact model designation of your
power tool.
See page 4.
A Support plate with velcro-type fastening (as
replacement)
B Adhesive intermediate disc
C Adhesive sanding discs
D Adhesive polishing sponge
E Lambskin adhesive polishing disc
F Adhesive polishing felt
G Adhesive sanding fleece
H Adhesive sanding screen
I Fluted filter (as replacement)
J Dust collection box (as replacement)
K Dust extraction connection
L Metabo universal vacuum cleaner
For complete range of accessories, see
www.metabo.com or the main catalogue.
10. Repairs
Repairs to electrical tools must be carried out by
qualified electricians ONLY!
Any Metabo power tool in need of repair can be sent
to one of the addresses listed in the spare parts list.
Please enclose a description of the fault with the
power tool.
11. Environmental Protection
Metabo's packaging can be 100% recycled.
Scrap power tools and accessories contain large
amounts of valuable resources and plastics that can
be recycled.
These instructions are printed on chlorine-free
bleached paper.
12. Technical Specifications
Explanatory notes on the specifications on page 2.
Changes due to technological progress reserved.
D
= Dimensions of sanding plate
P
= Nominal power input
1
P2
= Power output
n
= Idle speed
0
n
= Speed at rated load
1
s
= Orbital frequency at no load
0
s
= Orbital frequency at nominal load
1
S
= Oscillating circuit diameter
Intec
= Dust collection box
m
= Weight without mains cable
During operation the noise level can exceed
85 dB(A).
Wear ear protectors!
The technical specifications quoted are subject to
tolerances (in compliance with the relevant valid
standards).
ENGLISH en
7
Tabla de contenido
