Tabla de contenido
Idiomas disponibles
Idiomas disponibles
3. Predrill a pilot hole, using an ³⁄₃₂" drill bit, into the door panel
through the open holes in both the bottom and top hinges.
4. Using slotted hex-head screws (provided with refrigerator),
attach the top and bottom hinges to the door panels. Fully
tighten all door panel screws.
A
A. Top hinge
B. Mounting bracket
5. Using slotted hex-head screws (provided with refrigerator) for
each side, attach the door panels to the hinge-side door trims.
6. Using Phillips head flat screws (provided with refrigerator),
install the handle side door trim.
7. Completely tighten the screws attaching the mounting
brackets, located at the bottom of the doors, to the overlay
panels.
8. Reinstall the top door trim and hinge cover.
9. Snap the adjustment pin cover (provided with refrigerator)
into place.
Install Base Grille
There are two pieces to the base grille to allow for a custom fit: the
base grille itself and the skirt. The skirt can be added to the base
grille in order to extend it all the way to the floor.
1. To see whether the skirt is needed, place the base grille into
position. Do not attach the base grille to the refrigerator.
Measure the distance between the bottom of the base grille
and the floor. The gap must be a minimum of ¹⁄₂" (1.27 cm) in
order to add the skirt.
NOTE: If the gap measures less than ¹⁄₂" (1.27 cm), skip steps 3
and 4 of the instructions, and install the base grille only.
2. Remove the film from the base grille.
3. Snap the skirt onto the base grille.
A. Base grille
B. Skirt
B
C
D
C. Holes for screws
D. Adjustment pins
A
B
4. Trim the skirt by scoring the proper "V" groove with a utility
knife. Break the skirt at the score line.
A. "V" groove
5. Using the 2 screws, attach the base grille assembly to the
refrigerator as shown.
NOTE: Drive in the right side screw first.
A
A. Screws (2)
Complete Installation
1. Turn the water supply line valve to the "Open" position.
2. Turn the refrigerator switch to the ON position. See "Power On/
Off Switch" in the Use & Care Guide for instructions. Wait a few
minutes. Check the water line connections for leaks.
3. Remove all boxes, parts packages and packing materials from
the interior of the refrigerator. See the "Cleaning" section in the
Use & Care Guide for instructions. Remove the film and
cardboard from the grille and doors or door frame, depending
on your model.
4. Install the shelves and bins in the refrigerator and freezer
compartments.
5. The controls are preset at the factory to the midpoint setting.
Check that the compressor is operating properly and that all
the lights are working.
6. Flush the water system before use. See "Water System
Preparation."
To get the most efficient use from your new built-in refrigerator,
read the Use & Care Guide. Keep Installation Instructions and Use
& Care Guide near the built-in refrigerator for easy reference.
23
Tabla de contenido
