Idiomas disponibles
Idiomas disponibles
Important:
Unplug machine before replacing or
turning wheel!
1. Remove grinding wheel (Fig. 3)
2. Detach screw 2 (Fig. 1) using Allen
wrench. In the event that screw is
jammed, exert load moment against
grinding pad to avoid unnecessary
mechanical stress.
3. Replace grinding pad, or rotate to
desired position.
4. Re-tighten screw without exceeding
tightening torque of 5 Nm.
Important!
Possible attachments include circular
saw blades and diamond cutting blades
(Fig. 4). Always ensure that only suitable
attachments are used. Always observe
the relevant safety precautions.
Operating the machine
Important!
Always wear protective goggles when
operating the machine.
1. Switch on machine at switch 4
(Fig. 1) and set the appropriate speed
at button 3.
Note:
For optimal grinding, apply requisite
uniform speed. Applying excessive
pressure does not achieve improved
grinding results and increases heat build-
up.
2. When holding machine, do not
occlude vent slits 7 (Fig. 1).
Note:
In the event that machine overheats,
switch it off immediately and allow to
cool.
Care and maintenance
Important!
Unplug machine prior to maintenance!
Always ensure that vent slits remain
unobstructed.
Check power supply cable at regular
intervals for damage. In the event that
cable is damaged, have a qualified
technician replace it.
Disposal:
Please do not dispose of the device in
domestic waste! The device contains
valuable substances that can be
recycled. If you have any questions
about this, please contact your local
waste management enterprise or other
corresponding municipal facilities.
EC Declaration of Conformity
Name and address:
Product designation: OZI/E
Article No.:
In sole responsibility, we declare that
this product conforms to the following
directives and normative documents:
EU EMC Directive 2004/108/EC
DIN EN 55014-1 / 02.2010
DIN EN 55014-2 / 06.2009
DIN EN 61000-3-2 / 03.2010
DIN EN 61000-3-3 / 06 2009
EU Machinery Directive 2006/42/EC
DIN EN 60745-1 / 01.2010
DIN EN 60745-2-4 / 01.2009
Date: 10.02.12
Dipl.-Ing. Jörg Wagner
PROXXON S.A., Machine Safety Department
The CE document authorized agent is
identical with the signatory.
PROXXON S.A.
6-10, Härebierg
L-6868 Wecker
28520
- 7 -
