Installing The Infant Carrier - Graco Snugfix Manual Del Propietário

EN
GB
Choosing the
seat location
See fitting chart on page
63-66 when using the infant
carrier with base.
DO place infant carrier in a
18
forward-facing vehicle seat. The
seat can be placed on the rear
or front seat of the car (except
cars fitted with a passenger
air bag).
DO NOT place infant carrier in a
19
rear facing vehicle seat.
DO NOT place infant carrier in a
20
vehicle seat that uses an air bag
DO NOT place infant carrier in a
21
side-facing vehicle seat.
14
When using the infant carrier
without the base it must be
fastened in the car with a three
point belt with or without a
retractor, which has been
approved to ECE regulation
No. 16 or equivalent standard.
Only use this infant carrier on
vehicle seats with seat backs
that lock in place. Seats without
latches, that fold forward or pivot
freely should not be used.
Only use this infant carrier on
vehicle seats that are fully
padded and are free of sharp
objects.

Installing the infant carrier

After fitting the harness to your
baby and determining which
vehicle seat location is best, you
are ready to install your infant
carrier. The installation instruc-
tions vary depending on whether
or not you are using the base.
Step 1.
Place your infant carrier (or base
without the seat) into a
forward-facing vehicle seat with
no air bag and with an approved
type of seat belt. Face your infant
carrier or base toward the rear of
the vehicle. Check that the infant
carrier handle is up.
DO NOT use infant carrier in a
vehicle with the handle in the
sitting (down) position.
NEVER face this infant carrier
forward. Serious injury or death
can result if this infant carrier is
used facing forward.
Without base:
Step 2.
22
Place shoulder belt around the
back of the infant carrier exactly
as shown, making sure to run it
through the shoulder belt guides
on the back of the seat and
below the notch opposite the
shoulder belt origin.
Put lap section of belt over infant
carrier and under the two belt
hooks. Buckle the vehicle belt.
A Lap hooks
B Shoulder belt guides
C Notch opposite shoulder belt
origin
Step 3.
Push infant carrier down into
vehicle seat. Help the retractor to
take up all the vehicle belt slack.