Tool Use And Care; Loading Grease Gun; Cartridge Loading; Suction Loading - Alemite 596 Serie Instrucciones De Uso Y Mantenimiento

Ocultar thumbs Ver también para 596 Serie:
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 92

Tool use and care

Loading grease
gun
NOTE
Refer to parts listing († Fig. IPB 1,
page 14) for component
identiication on the following
procedures.

Cartridge loading

1 Unscrew grease cylinder (40) from gun.
2 Pull follower rod and engage groove in fol-
lower rod with slot in grease cylinder cap.
3 Remove plastic cap from cartridge.
4 Apply a ilm of grease to the exposed inside
surface of cartridge. This is only necessary
for a virgin gun.
5 Insert cartridge into grease cylinder.
– Remove tabbed seal from cartridge.
6 Screw grease cylinder onto gun.
7 Disengage follower rod from slot in grease
cylinder cap.
– Push follower rod into grease cylinder.

Suction loading

1 Unscrew grease cylinder (40) from gun.
2 Insert head of the grease cylinder below
surface of grease.
3 Slowly pull the follower rod outward from
grease cylinder cap until groove is visible.
4 Engage groove in follower rod with slot in
grease cylinder's cap.
5 Screw grease cylinder onto gun.
6 Disengage follower rod from slot in grease
cylinder cap.
– Push follower rod into grease cylinder.

Loader pump

1 Pull follower rod and engage follower by
rotating rod.
2 Seat loader itting into loader coupler.
– Push down to hold coupler valve open.
3 Operate pump and view movement of fol-
lower rod.
4 Discontinue pump operation once groove on
follower rod is visible.
5 Disengage follower rod from follower and
push into grease cylinder.
WARNING

The gun can be equipped with an
optional low-pressure loader itting
322610. Do not substitute with a
high-pressure grease itting. Personal
injury can occur due to excessive
pressure.
Use of a grease itting will void
warranty.

CAUTION
The loader itting on the gun must mate
with loader coupler. Pump may not
operate if components are not
compatible.
10

Priming gun

In most cases gun will prime simply by oper-
ating trigger several times. Should grease
fail to appear, air must be bled.

Force prime

This process manually assists air within gun
to be bled at bleed valve.
1 Pull follower rod and engage follower by
rotating rod.
2 Depress bleed valve (32) and at same time
push on follower rod.
3 Once air is eliminated, operate gun several
times.
4 Once grease appears, disengage follower rod
from follower and push into grease
cylinder.
Check valve contamination
Should gun fail to prime; outlet check may be
held open. Remove plug (44), clean ball (41),
and ball seat of head (21).
Tabla de contenido
loading

Este manual también es adecuado para:

596-a1596-b1596-c1596-d1

Tabla de contenido