Channel Level - Denon AVR-391 Manual Del Usuario

Channel Level

ui
1 Use to select "Channel Level",
and then press ENTER .
Channel Level
Test Tone Start
2
Press ENTER .
Output test tone.
ui
3 Use to select a speaker, and use
o p
to adjust the sound volume of
each speaker to be equal.
FL / C / FR / SR / SBRz / SBLz / SL / SW
Select the speaker.
z When the "Speaker Confi g." – "S.B(Pre)"
(vpage 7) setting is set to "None",
"SBL" and "SBR" is not displayed.
• –12.0dB – +12.0dB (0.0dB) : Adjust the volume.
• When o is pressed while the subwoofer volume
is set to "–12 dB", the "SW" setting switches
to "OFF".
• When "Channel Level" is adjusted, the adjusted
values are set for all the surround modes. To
adjust the channel level separately for the
different surround modes, use the operation
see page 27.
NOTE
• Speakers set to "None" in the "Speaker
Confi g." (vpage 7) settings are not displayed.
• When a headphones jack is inserted in the
PHONES jack of this unit, the "Channel Level"
is not displayed.
Remote control operation
buttons
Default settings are underlined.
The "Channel Level" settings are
Default
returned to the default settings.
• Yes : Reset to the defaults.
• No : Do not reset to the defaults.
4 Press to enter the setting.
ENTER
Test Tone Start
5 Press .
RETURN
Channel Level
n Outputting a test tone directly with remote
control operation
This is operable when the surround mode is
Dolby Pro Logic g, Dolby Pro Logic gx, or DTS
NEO:6.
q Press TEST
.
The test tone is output from the "L" channel
of the front speakers.
o p
w Use
to adjust the sound volume of each
speaker to be equal.
u i
e Use
to select the next speaker for
outputting the test tone.
r Once adjustment is completed, press
again.
Move the cursor
(Up/Down/Left/Right)
Crossover Freq.
ui
1 Use to select "Crossover Freq.",
and then press ENTER .
Crossover Freq.
Front :• 80Hz–
2 Use ui to select a speaker, and use
o p
to select the frequency.
Front / Center / Surround / S.Back
Specify crossover frequency
speaker.
• 40Hz / 60Hz / 80Hz / 90Hz / 100Hz / 110Hz
/ 120Hz / 150Hz / 200Hz / 250Hz : Set the
crossover frequency.
TEST
Confi rm the setting
Default settings are underlined.
• "Crossover Freq." can be set when the "Bass
Setting" – "Mode" (vpage 8) setting is
"LFE+Main", or when you have a speaker that
is set to "Small".
• Always set the crossover frequency to "80Hz".
When using small speakers, however, we
recommend setting the crossover frequency to
a higher frequency.
• For speakers set to "Small", sound below the
crossover frequency is cut from the sound
output. The cut bass sound is output from the
subwoofer or front speakers.
• The "Mode" setting (vpage 8) determines
which speakers can be set.
• When "LFE" is selected, speakers set to
for each "Small" at "Speaker Confi g." can be set. If
the speakers are set to "Large", "– Full –" is
displayed and the setting cannot be made.
• If set to "LFE+Main", this setting can be made
regardless of the speaker size.
Press to enter the setting.
3 ENTER
Crossover Freq.
Press .
4 MENU
The menu returns to normal display.
Return to previous menu
ENGLISH
Set up speakers
9