Checking Correct Operation - Westfalia 306 252 391 101 Instrucciones De Montaje

Ocultar thumbs

página de 41

/ 41
Contenido
Tabla de contenido

Tabla de contenido

Idiomas disponibles

Connecting the power supply

Depending on the vehicle type (with or without RDU fuse holder (Fig. 3/2) at the rear), power

must be connected as follows.

Version A (with RDU fuse holder):

Power is picked up from the RDU at the rear.

17. Lay the red cable to the RDU (Fig. 3/2) under the left-hand tail light.

18. Cut the cable to size and crimp the supplied small socket contact (Fig. 3/1) onto the cable

end.

19. Dismount the RDU and insert the socket contact of the red cable from below into position 7

(fuse F75). Then reassemble the RDU.

20. Insert a 15A minifuse into position 7 of the fuse holder.

Version B (without RDU fuse holder):

Power is picked up directly from the constant plus (+30) of the battery.

21. Lay the red cable on the left side along the vehicle's cable harness to the front into the engine

compartment. Lay the cable as shown in the vehicle drawing (Fig. 1 and 2).

22. Push the cable through the cable leadthrough (small leadthrough) under the rod system of the

windscreen wiper (Fig. 1/3, 2/3). Make sure that the cable is securely fastened.

23. Crimp the supplied large contact onto the cable end.

24. Let the quick-connect receptacle of the red cable of the cable harness and the individual red

cable lock into place in the fuse holder (Fig. 2). Close the secondary latch.

25. Connect the eyelet of the individual cable to the M8 screw terminal of the battery plus

distributor (Fig. 2/1).

26. Insert a 15A fuse and fit the cover.

27. Fasten the fuse holder to the plastic duct (Fig. 2/2) in a splash-proof manner.

Note: Ensure sufficient strain relief and correct installation of the fuse holder.

Special information concerning vehicles with parking distance control (PDC)

On vehicles with PDC it is possible to deactivate the PDC for trailer operation.

28. Lay the brown/white cable to the PDC control unit behind the left-hand storage rack (Fig. 1/5,

3/3).

29. Open the 16-pin plug and insert the contact of the brown/white cable into compartment 5.

30. Close the plug and plug it back into the PDC control unit.

Note: If the vehicle is not equipped with a PDC system, insulate the brown/white cable and

secure it properly.