Assembling The Rollers - Clatronic RA 2725 Instrucciones De Servicio

4....-05-RA2725-2728
• In order to avoid overheating it is important that the air inlets and outlets are
GB
kept clear. Never suspend objects in front of or above the radiator.
• Do not use the radiator in the open air.
• This radiator is not suitable for use in bathrooms, washing rooms or rooms
which are used in a similar manner. The radiator must never be placed in a
position where it could fall into a bathtub or other water container.
• Do not cover the radiator.
• The radiator should not be placed directly below a mains power socket.
• The radiator should only be used in an upright position.
• If the radiator should fall over, first remove the plug from the socket and allow
the radiator to cool down before returning it to an upright position.
• Before the radiator is used, the rollers must be attached.
• To do so, place the radiator upside-down (hold the underside facing upwards);
avoid hard surfaces.
• In the case of oil radiators with 5 to 10 fins, the rollers should be attached in the
right position between the first and second and between the last and penultima-
te fins. For models with 5-6-7 and 8 fins, the U-shaped roller carriers are used.
• For oil radiators with more than 10 fins, the straight roller carriers between the
second and third fin must be attached to both ends.
• Pass the U-shaped clamps through the holes of each roller carrier and then
tighten the wing nuts.
The heating power is determined by the various levels. In position 0 the radiator is
switched off.
= low power
= medium power
= high power
The control lamps light up during heating operation.
28
01.07.2002 8:39 Uhr

Assembling the Rollers

Levels/Heating Power
Control Lamps
Seite 28