I: Led Spotlight Illumination; J: Maintenance And Cleaning; K: Mounting Hood Instructions - Panasonic KH-B90FBC1 Instrucciones De Uso

I
LED SPOTLIGHT ILLUMINATION
The cooker hood is equipped with high effi ciency, low consumption LED spotlights with ex-
tremely long duration under normal use conditions. LED spotlight replacement must be carried
out only by qualifi ed technicians using only original spare parts.
J
MAINTENANCE AND CLEANING
Constant maintenance ensures the correct operation and effi ciency of the appliance over
time. Special attention should be paid to the metal grease-trapping fi lters and the charcoal
fi lters. Frequent cleaning of the fi lters and their supports will ensure that fats and grease do
not accumulate on the cooker hood, with the consequent risk of fi re.
1. METAL GREASE-TRAPPING FILTERS
These trap the fat and grease particles suspended in the air, and therefore should be
washed every month in hot water and detergent, without bending them. Wait until they
are completely dry before repositioning them. To remove and replace these fi lters, see the
instructions in point H1. This operation should be performed at regular intervals.
2. CHARCOAL FILTERS
These trap the odours present in the stream of air that passes through them. The air is puri-
fi ed by passing a number of times through the fi lters and being recirculated into the kitchen.
The charcoal fi lters cannot be cleaned, and should be replaced on average every 3-4 months
(according to use). To replace the charcoal fi lters, see the instructions in point H2.
3. CLEANING THE OUTSIDE OF THE APPLIANCE
It is advised to clean the external hood surfaces at least every 15 days in order to avoid that
oily or greasy substances affect the steel surfaces.
The outside of the cooker hood should be cleaned using a damp cloth and neutral liquid
detergent or denatured alcohol.
In case of fi ngerprint-less fi nish (fasteel) clean only with water and neutral soap using
clean with a soft cloth, rinse and wipe dry thoroughly. Do not use products that contain
abrasive substances or cloths NOT specifi cally designed for cleaning steel. Using abrasive
substances or rough cloths will inevitably damage the fi nish of steel. The steel surface
will be irrevocably damaged if the instructions above are not complied with. Keep these
instructions together with the instructions for use of your hood.
The manufacturer accepts no liability for any damage caused by non-compliance with the
instructions above.
4. CLEANING THE INSIDE OF THE APPLIANCE
The electrical parts or parts of the motor assembly inside the cooker hood must not be
cleaned using liquids or solvents.
Do not use abrasive products. All the above operations must be performed after having dis-
connected the appliance from the mains power supply. There is a fi re risk if cleaning is not
carried out in accordance with the instructions.
K
MOUNTING HOOD INSTRUCTIONS
Before performing the installation, defi nitely turn off the circuit breaker.
The ceiling must be fl at, horizontal and adequately load bearing. The wall plugs must have
a secure grip. The enclosed screws and wall plugs are suitable for solid brickwork or solid
17