Cleaning And Maintenance; Main Brush - cecotec CONGA 1690 Manual De Instrucciones

Use the direction buttons on the remote control or on the App to take the robot to the specific
points where you want it to clean.
Back home mode
This mode can be activated from the robot, the App or the remote control at any point of any
cleaning cycle. Once it is activated, the robot will automatically return to the charging base.
Spiral mode
Select this mode for the robot to carry out an intensive cleaning of a specific spot. It will start
cleaning at a specific point and will move outwards in a spiral motion. Then, it will return to
the starting point in a spiral motion, and will return to the charging base.

7. CLEANING AND MAINTENANCE

MAIN BRUSH

1. Turn the robot around and press the main brush's release button to take the cover out.
2. Take the main brush out and clean the compartment.
3. Clean the main brush with the provided tools and use water and soap if necessary.
4. Place the main brush in its position and fasten the cover's clip.
Note: Replace the main brush every 6-12 months to ensure efficient operating (depending on
the frequency and type of use).
DUST TANK
1. Open the robot's cover and take out the dust tank.
2. Open the dust tank, take the high-efficiency filter out and empty the dust.
1
2
3
4
1. Main brush cover
2. Clip
3. Main brush
4. Compartment
ENGLISH
33