Using The Machine - Clatronic DB 2707 Instrucciones De Servicio

4....-05-DB 2707
GB
NOTE: Only clothes should to be ironed with this machine.
Ironing without Steam (
1. Place the iron on its stand
2. Electrical connection
Make sure that the iron voltage (see name plate) and the line voltage match.
3. Sort out the garments according to their ironing temperatures. Start with the
lower temperatures. It is set with the thermostat:
• Synthetics, silk
• • Wool
• • • Cotton, linen
4. The LED lights up. As soon as it shuts off, the set temperature is reached
(approximately 3 min.). Now you can start to iron.
5. Always pull the plug out of the socket after using the iron.
Steam Ironing (
For this a high temperature is needed (cotton, linen). The quantity of steam can be
regulated using the steam quantity regulator (5). Extra steam can be added with the
steam jet function (4).
When ironing at low temperatures please ensure that you reduce the amount of
steam.
Vertical Steam
This can be used to produce a jet of steam in a vertical direction.
Self-Cleaning (Self-Clean
1. Half fill the water tank with water.
2. Heat the machine up to its maximum temperature. After the control lamp goes
off remove the machine from the mains supply.
3. Now hold the machine horizontally above a sink, turn the steam quantity control
to the self-cleaning symbol and rock it to and fro until the tank is empty. Then
turn the control back to "0".
4. Place the machine back on its stand and heat it up again. To clean the base
now iron over a clean cotton cloth.
Spray Function
In order to moisten a section to be ironed press the spray button (3).
28
06.02.2002 16:56 Uhr

Using the Machine

)
(low temperature)
(medium temperature)
(high temperature)
)
)
Seite 28