Connecting Peripheral Equipment - Philips 26PF9946 /12 Manual De Uso

Connecting peripheral equipment

The television has 2 external sockets situated at the back of the set (EXT1 and EXT2).
Remove the stand cover and the clip on rear panel of the television to expose the connectors.
Arrange the leads by passing them through the television stand. Replace the stand cover.
The EXT1 socket has audio, CVBS/RGB inputs and audio, CVBS outputs.
The EXT2 socket has audio, CVBS/S-VHS inputs and audio, CVBS outputs.
23"/58cm
26"/65cm
:
FM ANT
17"/44cm
:
FM ANT
Video recorder
:
FM ANT EXT 1
VCR
Other equipment
10
EXT 1 EXT 2
EXT 1 EXT 2
Carry out the connections shown opposite, using a good quality
euroconnector cable.
If your video recorder does not have a euroconnector socket, the only
EXT 2
connection possible is via the aerial cable.You will therefore need to
tune in your video recorder's test signal and assign it programme
number 0 (refer to manual store, p. 5).
To reproduce the video recorder picture, press
Video recorder with decoder
Connect the decoder to the second euroconnector socket of
the video recorder.You will then be able to record scrambled
transmissions.
Satellite receiver, decoder, CDV, games, etc.
Carry out the connections shown opposite.
To optimise picture quality, connect the equipment which
produces the RGB signals (digital decoder, games, etc.) to EXT1,
and the equipment which produces the S-VHS signals (S-VHS and
Hi-8 video recorders, certain DVD drives) to EXT2 and all other
equipment to either EXT1 or EXT2.
To select connected equipment
µ
Press the
from the EXT2 socket) and
front panel.
Most equipment (decoder, video recorder) carries out the switching itself.
AV in
AV 3
S-VIDEO
Audio Out VGA In DVI In
Audio Out Audio In
key to select ,
EXT1 EXT2
for connections on the
AV/S-VHS
Audio In
VGA In
ñ
.
/ (S-VHS signals
S-VHS2