Panasonic EY7881 Manual De Instrucciones página 13

3. Speed will increase by pressing the
trigger. The tool stops working
immediately by releasing the trigger.
4. When done with an application, lock the
switch by centering the lever.
NOTE:
When the brake operates, a braking
sound may be heard. This is normal.
CAUTION:
When operating the tool by pulling the
trigger, there may be a momentary lag
before rotation starts. This does not
signal a malfunction.
* This lag occurs as the tool's circuitry
starts up when the trigger is pulled for
the first time after installing a battery
pack or after the tool has not been
used for at least 1 minute (or at least
5 minutes when the LED is on).
Rotation will start without any lag
during second and subsequent opera-
tions.
Hammering/drilling switching lever
(C) / Speed setting button (K)
1. There are six modes available with the
combination of Hammering/ drilling
switching lever and Speed setting
button.
Select the suitable mode for applica-
tion.
2. Operate the mode change after the
motor rotation is completely stopped.
Position of Speed
switching setting
lever indicator
(Rotation
with
hammer-
ing)
(Rotation
only)
3 speed modes setting
Press the speed setting button (K).
The mode changes each time the
button is pressed.
H: High mode
M: Middle mode
L: Low mode
- 13 -
Recommended
application
This mode has
hard blow
hammering which
is suitable for
concrete drilling.
• Concrete drill
This mode is
suitable for
concrete drilling
with smaller
diameter drill, or
for drilling into soft
base material.
• Small diameter
concrete drill
By saving speed
and blow force, it
is suitable for
drilling with a thin
drill that is prone to breakege, or
drilling on a brittle
base metal.
• Smaller diameter
concrete drill
This mode is
suitable for metal
drilling with high
speed rotation.
• Metal drill
• Metal hole saw
• Stainless steel
drill
EN