Viking ME 545 Manual De Instrucciones página 38

Ocultar thumbs Ver también para ME 545:
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 109
Electrical connection
Power supply and operating
voltage must correspond (see
identification plate).
The mains supply voltage
must correspond to the
specified rated voltage of the
appliance.
The power supply cord must
be adequately protected by
fuse (see section "Technical
specifications").
Only connection cords which
are no lighter than rubber
sheathed cables H07 RN-F
DIN/VDE 0282 and have a
minimum cross section of 3 x
1.5 mm
2
for cable lengths up
to 25 m and 3 x 2.5 mm
2
for
cable lengths up to 50 m
must be used.
The connectors of the
connection cord must be
made of rubber or have a
rubber cover and conform to
the standard DIN/VDE 0620.
This machine is intended for
operation with a power supply
having a system impedance
of Z
at the transfer point
max
(house connection) of
maximum 0.47 ohms
(at 50Hz).
10
The user must ensure that
the machine is only operated
with a power supply which
meets this requirement. If
necessary, this information
can be obtained from the
local electric power company.
Strain relief
During mowing work, the
strain relief prevents any
unintentional disconnection of
the connection cord and
resulting possible damage to
the mains connection on the
appliance.
For this reason, the
connection cord must be fed
through the strain relief.
Form a loop with the
10= connection cord and
guide it through the
11= opening.
Pass the loop over the
12= hook and tighten.
Switching on the lawn
mower
NOTE
Do not start the motor in
high grass or when the
mower is set to the lowest
cutting height, as this
makes starting difficult.
11
1
Step
:
Press
S= start button and hold it
down.
2
Step
:
Press
R= Motorstop lever to the
handlebar and hold.
The start button can be
released again after
moving the motorstop
lever.
Switching off the lawn
mower
Release the
R= motorstop lever.
The motor and blade
come to a standstill
following a brief run-
down time.
CAUTION
12
Risk of injury!
Always disconnect the
mains plug when leaving
the lawn mower
unattended.
Switching on the
wheel drive ME 545 V
NOTE
The wheel drive functions
only when the motor is
running.
The vario drive lever (U)
must not be operated when
the motor is stopped as this
may result in damage to the
drive mechanism (lever is
blocked).
Step
1
:
Pull the
T= wheel drive lever to the
13
handlebar and hold.
The wheel drive
engages.
0478 121 9909 E - EN
14
Tabla de contenido
loading

Este manual también es adecuado para:

Me 545 cMe 545 v

Tabla de contenido