Camera Menu; Selecting Cameras; Scan Mode - Miniland digimonitor 5 Instrucciones De Uso

Note 1: If only one camera is connected to the monitor you will not be able to remove it.
Note 2: A channel will have to be removed before connecting it to a new camera unit.

5.2.7.8. CAMERA MENU

5.2.7.8.1. SELECTING CAMERAS

The device is designed to enable you to view different areas with up to four cameras. Take the following steps in
order to select the camera you wish to see:
1. Press the Menu / Back button (5) to access the menu.
2. Press the LEFT (9) or RIGHT (8) key until the camera select icon (H) is highlighted.
3. Press the UP (7) or DOWN (10) key until the camera you wish to see appears and press the confirmation
key (11).
Note 1: Only cameras that have been connected to the monitor can be seen.
Note 2: There is a faster way of changing the camera you wish to use. Press the select camera/ SCAN key (6)
to see the cameras that have been paired: CAM1 / CAM2 / CAM3 / CAM4 / SCAN MODE.

5.2.7.8.2. SCAN MODE

This function enables you to see the paired camera channels in a rotational sequence, displaying the images of
each camera for 12 seconds.
This function can only be used when more than one camera has been paired. To use this mode:
1. Press the Menu / Back button (5) to access the menu.
2. Press the LEFT (9) or RIGHT (8) key until the select camera icon (H) is highlighted.
3. Press the UP (7) or DOWN (10) key until the SCAN mode icon appears and then press the confirmation key (11).
Note 1: If one of the cameras is out of range or not turned on, the monitor will notify you and the Scan mode
will turn itself off.
Note 2: There is a faster way of activating the SCAN mode if more than one camera is connected. Press the
select camera/ SCAN key (6) to see the cameras that have been paired in loop mode: CAM1 / CAM2 / CAM3 /
CAM4 / SCAN MODE.
5.3. TROUBLESHOOTING
Problem
No reception on
monitor
Only black and
images are displayed
The camera does not
transmit
You cannot hear the baby
on the parent unit
Possible Cause
the Camera not turned on
Monitor not turned on
Camera: not plugged in to the
power adapter
Monitor: The power adapter is not
plugged
Monitor out or range
Connection lost
monitor and a camera already
linked
A wrong camera has been selected Change the camera number you are
white Check whether the camera is in
night vision/infrared mode
The camera is not turned on
Camera: the power adapter is not
plugged in
VOX mode or Standby mode are
active
The volume setting of the parent
unit is too low
Solution
Press and hold down button (III) for 2
seconds
Press and hold down the Power button (12)
Plug in the power adapter
Plug in the power adapter
Move the monitor closer to the camera
between the Link the camera with the monitor again. See
5.2.7.6.
watching. See 5.2.7.8.1.
In order to view the images in colour,
increase the level of light in the room the
camera is in or check there is nothing
covering the camera´s light sensor (II).
Press and hold down button (III) for 2
seconds
Plug in the power adapter
To see the monitored area continuously,
disconnect the VOX or Standby mode on
the Monitor
Set the volumen to the highest level
17
ENGLISH