Sharpening Saw Chain - Worx WG300 Manual De Instrucciones

Worn Groove
Replace the guide bar when the groove is
worn, the guide bar is bent or cracked, or
when excess heating or burring of the rails
occurs. If replacement is necessary, use only
the guide bar specified for your saw in the
repair parts list or on the decal located on the
chain saw.
Replacing Bar & Chain
Replace chain when cutters are too worn
to sharpen or when chain stops. Only use
replacement chain noted in this manual.
Always include new drive sprocket when
replacing chain. This will maintain proper
driving of chain.
Inspect guide bar before sharpening chain. A
worn or damaged guide bar is unsafe. A worn
or damaged guide bar will damage chain. It
will also make cutting harder.
Fit the Bar Tensioning Plate catch into the new
bar by tightening the screw clockwise. The
catch protrude (b) must be fitted into the bar
hole (See Fig. N).
18

SHARPENING SAW CHAIN

WARNING: Unplug chain saw from
power source before servicing.
Severe injury or death could occur from
electrical shock or body contact with
moving chain.
Cutting edges on chain are sharp. Use
protective gloves when handling chain.
Keep chain sharp. Your saw will cut faster and
more safely. A dull chain will cause undue
sprocket, guide bar, chain, and motor wear. If
you must force chain into wood and cutting
creates only sawdust with few large chips,
chain is dull.
LUBRICATE SPROCKET
WARNING: Wear heavy duty gloves
when performing any maintenance
or service to this tool. Always unplug
the tool before performing any service
or maintenance on this tool.
Electric Chain Saw
File Rail Edges
and Sides
Square
Correct Groove
NOTE:
It is not necessary to remove the chain or bar
when lubricating the sprocket
1. Clean the bar and sprocket
2. Using a grease gun, insert the tip of the
gun into the lubrication hole and inject
grease until it appears at the outside edge
of the sprocket tip (See Fig. O).
3. To rotate the sprocket release the chain
stop and pull the chain by hand until
the ungreased side of the sprocket is in
line with the grease hole. Repeat the
lubrication procedure.
EN