Sharpening Saw Chain - Worx Jawsaw WG329E Manual Original

WARNING: (See Fig. X)
• If on slope, make sure log will not
roll down hill. Secure log by using
wooden stakes. Drive wooden stakes
into ground on downhill side of log.
Stand on uphill side of log while
cutting. Log may roll after cutting.
(See Fig. X)
• Never try cutting through two logs
at same time. This could increase the
risk of kickback.
• While cutting log, never hold log with
your hand or leg.
• While cutting log, never allow another
person to hold log.
• Turn off and remove the battery pack
from the saw before moving from one
place to another.
SAW MAINTENANCE AND
KICKBACK SAFETY
Follow maintenance instructions in this
manual. Proper cleaning and maintenance of
18
the Saw Chain (8) and Guide Bar (7), as well as
the JAWSAW in general, can reduce chances
®
of kickback. Inspect and maintain saw after
each use. This will increase the service life of
your saw.
NOTE: Even with proper sharpening, risk of
kickback can increase with each sharpening.
MAINTENANCE AND
STORAGE OF JAWSAW
1. Remove the battery pack from the saw:
• When not in use.
• When transporting.
• When left unattended.
• Before servicing.
• Before cleaning.
• Before changing accessories or
attachments, such as Saw Chain and
Guard Bar.
2. Inspect the saw before and after each use
for:
• Any signs of damage.
• Smooth action of push handle and
Cordless Limbing and Trimming Chain Saw
movement of bar.
• Adequate Chain Tension; you should be
able to lift the Saw Chain from the Guide
Bar no more than 3 mm.
• Adequate chain lubrication.
3. Do not use the JAWSAW
• The Trigger Switch (2) or Lock Out Button
(3) is malfunctioning.
• The Rear (Push) Handle (1) does not
smoothly return under spring force.
• Any other damage which affects the safety
or operation is evident.
4. Maintain the JAWSAW
have any damage or malfunction repaired
by an authorized service center:
• Never expose the JAWSAW
• Keep Saw Chain sharp, clean, and
lubricated for better and safer
performance.
• Follow steps outlined in this manual to
sharpen Saw Chain.
• Keep handles clean and free from oil.
• Keep all screws and nuts tight.
5. When servicing, use only identical
replacement parts.
6. When not in use, always store JAWSAW
• In a high or locked place, out of children's
reach.
• In a dry place.
REPLACING SAW CHAIN/CHAIN BAR
Replace the Saw Chain when cutters are too
worn to sharpen or when chain breaks. Only
use replacement chain noted in this manual.
Always include new drive Sprocket (16) when
replacing the Saw Chain. This will maintain
proper driving of chain. Inspect Guide Bar (7)
®
before sharpening chain. A worn or damaged
guide bar is unsafe. A worn or damaged Guide
Bar is unsafe, will damage the Saw Chain, and
will make cutting harder.
For Replacing the Guide Bar please refer to
CHANGING THE GUIDE BAR AND CHAIN
section in the Adjustment and Assembly
Instructions.

SHARPENING SAW CHAIN

WARNING: Remove the battery
pack from the saw before servicing.
Cutting edges on chain are sharp. Use
protective gloves when handling chain.
, if:
®
with care and
®
to rain.
®
®
EN