Password; Change Password; Inspection; Maintenance - Roger Technology B70-2DCHP Instrucciones Y Advertencias Para El Instalador

P1 00
P2 00

Password

P3 00
P4 00
CP 00

Change password

Storing a password enables the data to be protected in the memory, only allowing those who know
it to change its value. The procedure for entering the password is as follows:
• enter the eight numbers chosen for the password in parameters
• view parameter
seconds. When the display flashes it means that the new parameter has been saved.
The protection is activated immediately after turning the control unit off and on again or after 30
minutes of inactivity when the display switches to standby mode.
WARNING! When password protection is enabled, the + and - buttons do not allow the value of a
parameter to be changed and the parameter
Unlocking parameters procedure (temporary): enter the password previously stored in parameters
p1 p2 p3
, ,
deactivated).
You can only delete the password if you know it, by proceeding as follows: enter the password, then
store the password
CP
parameter
If you have forgotten your password, you can unlock the control unit by contacting support.
5

Inspection

Check the response to all of the commands
connected.
Check the stroke and the slowdowns.
Check the impact forces.
Check the behaviour when the safety protections
intervene.When the anti-crushing protection is
checked be sure to move away from the limit switch
or obstacles which increase the risk of crushing.
If the battery kit is installed: disconnect the mains power
supply and check the battery operation. Remove the
mains supply (and disconnect the battery), power on
again and check that proper repositioning is completed.
6

Maintenance

Perform scheduled maintenance every 6 months by
checking the condition of cleanliness and operation.
If there is dirt, moisture, insects or other items, cut
the power and clean the card and the container.
Perform the inspection procedure again.
In the case of noticing oxide on the printed circuit
consider replacing it.
Check the battery charge by performing a complete
operation and measuring the voltage at its terminals
CP
: on the display: simultaneously press and hold the + and - buttons for 4
P4
e then view parameter
p1 00 p2 00
,
.
CP 01
has value
CP
n the display and check that its value is
p3 00 p4 00
, ,
7

Disposal

The product must always be uninstalled by qualified
personnel using the appropriate procedures for the
correct removal of the product.
This product comprises various types of materials,
some can be recycled others must be disposed of
through recycling or disposal systems provided by local
regulations for this product category.
This product may not be disposed of in household
rubbish. Perform a separate collection for disposal
according to the methods provided by local
regulations; or by returning the product to the seller
when purchasing a new equivalent product.
Local regulations may include severe penalties in the
event of improper disposal of this product
Warning: some parts of the product may
contain toxic or hazardous substances,
if dispersed they could cause harmful
effects to the environment and human
health.
p1 p2 p3
, , e
.
, remembering to confirm it with
P4
00
(protection
43