Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Bevel cutting
CAUTION:
Always be sure that the tool is
switched off and unplugged before tilting the
base.
CAUTION:
Raise the dust cover all the way
before making bevel cuts.
With the base tilted, you can make bevel cuts at any
angle between 0° and 45° (left or right).
Fig.7
Loosen the bolt on the back of the base with the hex
wrench. Move the base so that the bolt is positioned in
the center of the cross-shaped slot in the base.
Fig.8
► 1. Hex wrench 2. Bolt 3. Base
Tilt the base until the desired bevel angle is obtained.
The edge of the motor housing indicates the bevel
angle by graduations. Then tighten the bolt to secure
the base.
Fig.9
► 1. Edge 2. Graduation
Front flush cuts
Fig.10
► 1. Hex wrench 2. Bolt 3. Base
Loosen the bolt on the back of the base with the hex
wrench and slide the base all the way back. Then
tighten the bolt to secure the base.
Cutouts
Cutouts can be made with either of two methods
"Boring a starting hole" or "Plunge cutting".
Boring a starting hole
1
2
3
Fig.11
For internal cutouts without a lead-in cut from an edge,
pre-drill a starting hole 12 mm or more in diameter.
Insert the jig saw blade into this hole to start your cut.
Plunge cutting
1
2
Fig.12
You need not bore a starting hole or make a lead-in cut
if you carefully do as follows.
6 ENGLISH
1
2
3
Tabla de contenido
