Elite SI 9200 MP Manual De Instrucciones página 36

Connections
Setup machine as per three pictures below:
Fig 1 Fig2
1. On/Off Power Switch (See Fig 2 No.13)
This turns the Mig Welders on and off.
2. Earth / Workpiece (TIG) connector ( See Fig1 NO.9)
Connect the earth lead (negative - ) to this connector
Insert male connector into socket and twist clockwise until tight
Secure other end of earth lead to Workpiece via the earth clamp.
3. Euro welding torch connector (See Fig 1 NO.8)
Connect the Mig toch lead to this connector
4. Gas inlet connection (Seee Fig 2 No.11)
Connect gas hose to rear of machine and then to regulator on gas bottle. Ensure all
connections are tight to ensure no loss of gas.
5. Mains input cable ( See Fig2 No.12)
Fit required plug as per your electrical installation