Elite SI 9200 MP Manual De Instrucciones página 20

Keeping these contributing factors in mind, installing equipment as per following
instructions should minimize problems
1. Keep the welder input power lines as short as possible and enclose as much of them
as possible in metal conduit or equivalent shielding. There should be a good electrical
contact between this conduit and ground (Earth)
2. Keep the work and electrode leads as short as possible. Tape the leads together
where practical
3. Be sure the torch and earth leads rubber coverings are free from cuts and cracks that
allow welding power leakage
4. Keep earth lead connection to work in good condition – Clean area on workbench
where earth clamp is situated on a regular basis.
Input Connections
Make sure the voltage, phase and frequency of input power is as specified on machine
rating plate located at rear of machine.
Have a qualified electrician provide suitable input power.
Turn the input power OFF at the mains switch before working on this equipment.
Have a qualified electrician install & service this mig welding equipment.
Allow machine to sit for 5 minutes minimum to allow the power capacitors to discharge
before working inside this equipment. Do not touch electrically live parts.
The multi process ELITE MP 200 Welders require a 95-270V 50/60Hz 1-Phase supply.