Elite SI 9200 MP Manual De Instrucciones página 24

Wire Spool Fitment
Fig 4
1. Roller tensioner
Do not over tighten wire feed pressure roller as this can cause premature motor and
roller failure. Correct way t adjust tensioner is to slacken off pressure so that mig welding
wire does not feed, slowly adjust pressure until wire feeds smoothly, you should be able
to stop wire feeding by holding wire and it should slip on rollers. If you have too little
pressure wire will slip when welding causing unwanted Burn back into tips
2. Wire Feed Drive Assembly
Make sure rollers are correct size for wire diameter selected, to change roller size
release
retaining screw, remove roller turn roller around and slide onto shaft making sure the
right size groove is in line with wire and refit retaining screw. The TOPMIG135C,
TOPMIG165C,TOPMIG195C and TOPMIG215C come fitted with a dual roller 0.6mm
and 0.8mm
3. Wire reel adaptor
Remove the wire reel adaptor, slide on roll of wire and refit the reel adaptor (This can be
reversed to suit different manufacturer's reel sizes)